Jump to content

Recommended Posts

Posted

I have an issue with disengaging the trimmer, is it possible to disengage the trimmer without the Ka-50 being thrown into an almost full nose up position?...it does this every time I try to disengage it.

Posted

If by disengaging you mean reset the trim, that's "normal" behavior.

 

The "untrimmed" position is the park position.

At that, the nose is pointing slightly below the horizon compared with normal flight or hover (at the extreme).

That untrimmed position at mission start prevents the helicopter from moving if wheel brakes are disabled but will make the nose pitch up violently in flight when trim is reset.

 

However there is no trim reset function in the real Ka-50 and I for my part haven't used it more than a few times when BS1 was originally released.

There is no need for a trim reset function in my eyes and I don't even have it mapped because of that.

Get in the habit to always trim for every change in attitude, even trim when just taxiing and soon you will find no use for the trim reset anymore.

 

Greetings

MadCat

  • Like 1
Posted

If you must disengage the trim, you should not do it in forward flight, but as your stick approaches the center position to slow down.

[sIGPIC][/sIGPIC]

Posted

You might also find the controls indicator useful in this situation (RCtrl+Enter)

i5 4590 @ 3.77GHz | GTX 1060 6GB | 16GB 1600MHz DDR3 | 1TB HDD+500GB HDD | Win10 Home X64

[sIGPIC][/sIGPIC]

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...