bmodrow

Mission 5 Basic Maneuvers Bug In Mission 5 after diving to 7000' , the instructions given are maintain 220 knots at heading 040 at 7000'. Nothing happens after this point. The same behavior is exhibited in the practice mission. DCS Open Beta 2.5.6.50979 Edit: Just flew practice mission again and got past this point by flying below requested altitude.

I recently had the same issue. The work around is to download DCS and install. Then download modules one at a time. If I tried to download more than one module at a time, the download would hang.

My mistake...hopefully their throttle comes to fruition this year.

You can also check out VKB controllers at https://vkbcontrollers.com/ They make some nice hardware. Items in stock will make it to the US in 7-10 days.

You are welcome. Glad you got it working.

With what I described to you, yes you would have to move the cursor to the right to get into the left screen or when not playing DCS just swap the Windows settings. Hope that makes sense. What I described to you as a set up in windows also gives you the lowest pixel density which will be way less taxing on your system. Again in Windows: [Monitor 1 Primary ] [Monitor 2 ] ...........................[M3][M4] Physically on desk: [Monitor 2 ] [Monitor 1 ] and M3 & M4 where ever you want. Sorry last post was a bit of a pain to understand was on a mobile device.

Bob there is really not an issue with TrackIR. I would more term as an inconvenience. Not really a reason to not get TrackIR as it works wonderfully if you are not fixated on a framerate greater than 60FPS. It is very easy to configure your system to work fluidly with TrackIR has long as your system can run DCS fluidly. If you are not flying VR, once you use a TrackIR you will never go back to flying without it.

Windows does not know where your monitors are physically located. Setup your displays in Windows to be as such: Monitor1. Monitor2 M3 M4 Monitor 1 will need to be set as primary display. Also make sure extend displays is checked. Physically on your desk: Monitor2. Monitor1 and M3 & M4 where ever you want. You will use Monitor1 .....................M3 M4 Pixel dimensions/locations to set your viewports and in game.

Did you just add the two smaller LCDs to your setup? I suspect for MFDs? If so, and if you want to run with LCD MFDs you are going to have to really drop your graphics settings to get acceptable framrates. This seems to be a limitation on how DCS handles viewports. The LCDs in my MFDs now remain off and disconnected from my PC. They look real nice but kill performance big time. I have the same issue as you. My main screen is 3440 x 1440 and two screens for MFDs 1280 x 800 on an RTX 2080 Super. I want smooth flight dynamincs which means....no pretty MFDs.

https://forums.eagle.ru/showpost.php?p=2616874&postcount=799 Refer to the above link. I would recommend you move 3 and 4 under monitor 2 in the left corner. Total pixels will be slightly less.