Joker73

Finally , is gone.... One thing i could tell you for pass the test is i 've pressed the t/o button again just before the end of time to disposition.

I 've tried to do that, also pressing T-left ctrl to reset trim after that step, but always instructor tell me i fail t/o trim reset test. I think i don't like him :cry:

Hi , i do the start up procedures as usual but always in this mission at the end of time i fail The " t/o trim test". I don't understand why it happend because as usual after begin the bit test i set the flight control system and the take off trim...Someone knows why ?

The func 0 is the botton i push after create the new waypoint , just for looking info about the steerpoint so as you told me, i already hit before OSB next to the 9.

Always "cdu error input" i received. This is the mission freeflight - Joker.miz

Ok , i do the start up , afetr take off i switch the cdu from "flightplan" to "mark" , push function 2 and choose waypoint to prepare insert coordinates. Then i contact jtac , do check in and receive 9 lines with the coordinates "fh699680" that i put in to the cdu switching to upm and insert it as new waypoint number 9. At this point when i push fuction 0 (steer) and i type 9 follow the botton under osb 19 i receive always "cdu input error" even i create the new waypoint.

Hi , i saw many videos on youtube about jtac , this in particularly . In the mission i created i put the coordinates on the cdu and create the markpoint , 9 in my case , but when i try to put it in to the steerpoint info on the cdu as in the video , always i received "cdu input error" and i don't understand why. Any suggestions? Thanks.

Thanks for help , i'll try it later.

Hi , i can't access to beta forum even i do all the steps. i don't know why , i try everythings... can you help me?

Hi , no i can't access to beta forum even i do all the steps. i don't know why , i try everythings... can you help me?