chamol

Installer comme tous les autres mods avec OvGME. J'ai bien le wallpaper mais pas l'appareil...Une astuce pour l'install ? PS: J'ai le module du F18

I disabled mods for clouds and one for syria. Did a repair, a cleanup. A quick check launching the mission showed that everything is now ok. Thx

Hi ! Well I tried again today the behavior was the same. Even if this time, tomcats were not moving at all even at 14h33. You can see that the position of the tomcat is moving as the carrier moves. The other tomcat did not move. I have done screenshots up to 14h33. Best regards

Hi, I tried M10 yesterday after the update and unfortunatly, it is still too crowdy on the deck. The two F14 finally went off (but because there is a bug that moves slowly the two F14 with carrier moving, the F14s were stuck). Two F18s stayed stuck on the deck (sluggo is on of them).

Indeed, i checked it yesterday and Cajun does not move from the tanker until i say that i am good without having been able to connect with the tanker. Couldn't have time to finish it so I don't if i would have enough fuel to be diverted..

Well, I will try it again...and wait a bit. It would be a pity if I have to skip this one.

Hi, Just finished for the second time, raven one and decided to jump to this new set of mission. A bit disappointed because it seems that i could not have cajun move from the tanker...so i could not refuel myself. Not enough fuel for the case III recovery with everyone... I missed something or AI messing up again ?

First target does not have specific difficulties. indeed try to complete the second task several time without success since I got shot by SA even if I am in close formation with leader to follow the same route. I don't even know if i was able to spot the target, i definitely spotted something. One of the possible thing to do i to announce coordinates with a F10 communication if the player wishes to (pretty sure a scenaristic trick could be done to keep the immersion). Nevertheless I have never been able to shoot to the target. I will skip the second step...

Another mission to spot...unspotable...man pads... with only RE with a faulty calculation...shot by sams... this is going to be fun...especially in VR.

only found one of the two sa19 or S9 since a tornado got shot. As usual in mission where you have to spot something it is a mess and never spot a thing especcially when you have a lot of unit in the area. mission finished by shooting a mig and another on fled.

ok thx. I will try this then

I got shot every time by manpad in airport mission 9 while I would to delivery RE bombs after shooting my mavericks on primary targets... Do i need to get rid of all AAA their or SA19 and 9 is enough ?

perfect thx !

I did a roll back on previous DCS version. Do you know if the latest update corrects Opentool kit issue ?

It was indeed the right thing to do. Thx ! An ok it is writen in the troubleshooting section but, for me (non native english speaker and not a software expert) this is totally unclear: Enabling safe mode You may then either: Reset all the settings. Change your settings to avoid the problem. Note that in safe mode, settings are not loaded, but the modified settings are still stored. You may need to toggle a setting on/off a few times to make sure the new value is saved before exiting Safe mode. If if was explained just the way you did : "run in safe mode and restore default settings and be sure to confirm " that would be quite enough.

When I switched to safe mode, all option in openXR tool kit are disable. I checked again that retroprojection is off in OpenXR and in tool kit options. Does not chnage behavior. So, i guess just the tool kit enabled that crashes at dcs at launch. I also deactivated all third party sofware launch like openkneeboard and voice attack.

Very same for me with a reverb G1. DCS stops a few second after launch. Retroprojection does not affect. Only safe mode or disableling the took kit works.

On my side, I think i am going to skip this mission...pretty sure I am doing a lot of things wrong but I can't pass it. 1) 50% chance to have to the "Thunderstorm" code name...I don't understand quite when I have to dump fuel and how many times 2) Got shot several times by the northern SA2 after bombing the facility, 45° left turn, countermeasures etc... 3) when i managed to dodge the SA2 (hardcore dive), following the route to go back and then I got shot by F5's...Come on !!! Don't misunderstand what i am saying here, I love the campaign (and others of your work A10 for instance) but 40 minutes before some actions to get shot or just get back...too much frustration.

Ok I will try to find it. Since I have the exact coordinates and I think i tried with the sea radar but I am not sure. I will edit this post to tell you if it is ok. Edit: I did the mission with your advice. I shot the boat and get back to the stennis. Next mission !! Reagrds

Thx for your help. I followed your guidance as requested. Unfortunatly, the trigger with the boat did not go. Therefore I can't go further with the mission. No problem, I know that ED is changing things each update so they break triggers from time to time. As I may not have mentionned, I run with Open Beta.

unfortunatly there is no F10 menu. the mission cannot be continued.

infortunatly, i tried to park where as requested but it does not work. in my mission, The humvee stops where the truck is on the yellow line, i stop between the two double red lines and the refule truck stops around the yellow line and red line cross about 15 meters from the humvee. ps: crosswind is very nice, a pleasure not a challenge thx for that.

hi, In Mission 7, you make a stop in Batumi to refluel. You land with a high crosswind and have to follow a vehicule, stay behind and stop behind it. Then a truck is coming to refuel. In my case, it seems that the truck is stuck behind me/next to me a bit behind, therefore there is no trigger activating. Even if i laucnh the command to refuel, and refuel my F18, nothing happen and the mission cannot continu. regards