jeepster

in 2.8 i saw 90fps in main menu and f10-map, after updating to 2.9 there are 25 frames left. while playing missions frames are ok. using an options preset without any new settings. G2, RTX3090, 64GB RAM Any ideas what’s going wrong?

Bisher hatte ich nach dem Start von DCS in VR auf dem Auswahlbildschirm 90 fps, nach dem Patch finde ich mich bei 25 fps wieder. Starte ich eine Mission steigen die Frames wieder auf 50-60fps, wie vorher, aber mit völlig unscharfen Texturen. Ich habe keine Einstellung gegenüber vor dem Patch verändert, da ich ich mit Presets arbeite. Es ist also nichts von diesen neuen Zaubereinstellungen in Benutzung. Wie komme ich wieder zu meinem gewohnten Bild ? HP Reverb G2, NVidia Geforce RTX 3090 , 64GB RAM

Same here, no Necksafer involved. OpenComposite is a workaround.

I try to understand the fundamentals of interception und read the relevant chapters in P-825. To build a gameplan for a stern conversion the most important thing seems to determine target aspect (ta) to compute and build lateral separation as turning room. For T-45 they use the TA Vector shown on the trackfile symbol after locking the bandit. But this graphical procedure seems to be a roughly estimation. How does this procedure work in the hornet ? Is ta computed and shown anywhere ? All relevant data seem to exist because the ddi is drawing a vector. Does the following calculation leads to an accurate result ? TA is defined as angle between bandit bearing (bb) and bandit reciprocal heading (br). After locking the bandit the ddi shows bandits heading so that it is easy to calculate br. bb should be delivered by the bra information also from the ddi. the difference between both angles should be ta. Can someone with expertise please take a look at it ?

That makes sense. tried it on nttr with a mag var of -12. thank you.

that was what i thought too, but I'm getting a deviation of 10-15 degrees. any idea ?

if I lock a target bra is shown on the ddi with heading and range. if i turn the nose onto the target should i read the same heading ?

i missed the latest update, my fault, problem solved

I am on openbeta

I bought BS3 yesterday and want to install it now. usually the module manager gives a hint that a new module is available for installation. but in this case bs3 seems to be unknown. what can i do to install bs3?

I am completely frustrated. I can' t get over mission 3. The final MiG attack is one target too much. The mission costs me 1,5 hour playtime and i tried it 5 times, always shot down by the MiG. She is firing her missile at me before i can even see her, neither on the radar nor visually. Now i'm finished. No further 1,5 hour of my precious lifetime.

fixed the problem by reinstalling va and vaicompro.

as a vr player i like to use the dictation function implemented in the kneeboard extension to grab coordinates from the f10 map. since the last update of vaicom i can start dictation as always but can not finish it. the command "end dictate" is recognized with a confidence of 95 but the log shows an orange comment "PTT: use an active TX node". help welcome.

checked it in single player and had the same issue as in mp 2 tanker, texaco (252Mhz) and Arco (251Mz). i tune 252Mz and ask texaco for refueling, player voice calls texaco, texaco answers, i abort refueling now i tune 251Mz and ask arco for refueling, player voice calls texaco on arco freq and gets no answer

i get a very simular issue. multiplayer, several tankers, vaicom takes a random tanker independently what freq is tuned