video set Joystick Logitech Force 3D Pro for Dcs black shark ka 50

This is video Training setup Joystick Logitech Force 3D Pro for Dcs black shark ka 50. only for Logitech Force 3D Pro. this set very Perfect..........

thank you for watch................. :music_whistling:

Good catch! - I knew that the tools are doing great work in the proper hands!

corrupt calibration? crazy joystick response? Use this tools Fix it:

Interesting video, thanks.

Nate

good video, but ive been down that road. it took me over a year playing off and on intil i mastered the Force 3D Pro. U know, the sensitivity, the notorious shaking.

Easy set up ( ALL BLACKSHARK )

1. Uninstall the Logitech Game Profiler (Never install again,ever) --its adding to the sensitivity:joystick:

2. Run BS , set the y saturations around 70 for both axes.leave the x axes at 100. set the curves for both axes around +50 x axis

3. do a center test, by pulling the stick in one direction then letting go.the stick probably didnt go back perfectly center. add a little deadzone. +4

4. make the throttle a slider, then put a slight curve in it, like 30. Rudder- reduce the y saturation to around 70, curve around +40, 5 deadzone

5.the shaking part, i found out, that BS Forces are too strong at 100%, thats y the stick spazzs out and starts shaking. In BS, reduce the FFB to 70% and the shake to 50%. Shaking GONE!!

Take her for a spin!!

Try BlackSharks Forces, u wont be disappointed

im going to get the G940 one day and set it up the same way

Do I see it right? 90% deadzone set for axes?!

he has too, all that extra tweaks is just to balance the crappy Logitech Profiler. basically too many axes makes it dumb.

I still don't get it. There is no case where 90% deadzone would be appropriate for any kind of use.