Saitek X52 Collective not working

Hi there,

I have the latest edition of Blackshark 2 and A10C versions 1.1.1.1 and I've been unable to get the collective or throttle working. Everything else works pitch yaw etc., but the collective and thrust have been switched with the slider and I'm unable to switch it.

Under Controls and Axis Commands I see pitch, roll, rudder and thrust but I don't see Collective in the list.

Saitek Flight Control is listed in a column but they are all blank and if I right or left click there are no options and Add and Clear are dimmed out.

Would really appreciate any help.

Thanks in advance

System:

Dell Studio XPS 9100 i7CPU 930 2.80GHZ

12GB Ram

Controller Saitek X52

Make sure when you go into the "controls" section of the options menu, the window is set to "Ka-50 sim." The simulation has a tendency to be in "Free Camera" when you first open up the "controls section."

Check that out.

See screenshot.

I have the same problem whit my A10-C profile... trottle whont work fine and about 4 or 5 min they go in conflict (i dont Know How) and even if I leave the Throttle stop, start moving back and forth on its own...

If I dont use profile but set command from option of A10-C I have no Problem with the trottle!

Thanks so much for your help guys, I didn't have KA-50 selected.

Now I can finally start enjoying the game.

All the best in the New Year!

I sometimes do the mistake that Aldega has showed. Joy_Z... :)

Hi everyone,

I have the same problem as above in BS2. I configured my saitek x52 in options menu (in game and sim), set the throttle as collective, I can tune the axis. But when I start the game the throttle not respond. I wrote to Saitek and DCS team, but they do not respond.

Regards

my bad mine works with no problems check other setting by checking all

As you see I have no problem to configure throttle in controls menu, it works properly. But when I start the game, the throttle does not responding. I bought BS2 2 weeks ago, before BS2 I had the DCS Black Shark, and there was no problem.

try selecting it as a SLIDER

Post a (short) track where you move the controls through the entire range.

http://youtu.be/fTC7MdDuz3Q

Very strange ...

You could try deleting your current X52 control configuration and configure it again.

To be sure, only configure the axis assignments, and don't import X52 settings using "Load Profile".

The file is in the following directory:

C:\Users\your-user-name\Saved Games\EDBackups\DCS BlackShark 2\Config\Input\ka-50\joystick\

PS: it seems you are still using the standalone version of Black Shark 2, instead of DCS World with Black Shark 2 module. I recommend trying out DCS World 1.2.2, it may fix some issues.

I just back from work, and start again from start point (uninstall BS and BS2 with all config files, saves..), I will install only BS2 and try again. Few minutes ago I recieve support from DCS team, I'll try to use all advices in this fresh install. I'll post how's goes.

Thanks in advance for all involved

"She's alive!" :megalol:

There is only problem with inverse, don't work even when I select axis as a slider or change the curve in reverse order. :pilotfly:

Thanks for everyone