Zooker Posted November 29, 2016 Posted November 29, 2016 I'm attempting to program the G keys on the 510 to manipulate my HSI, heading, course, etc. I'm not finding any success in getting the programmed keystroke to pass through to DCS. Is this possible? If so, how do I set this up so that it works? I did a search and posts specific to this issue are seemingly non-existent. Any help is appreciated. Thanks. VF-111 Sundowners [sIGPIC][/sIGPIC] Carrier Group 1 - Battlegroup Delta Beware the lessons of a fighter pilot who would rather fly a slide rule than kick your ass! -Commander Ron "Mugs" McKeown, USN Commander, U.S. Navy Fighter Weapons School 2 Victories, Vietnam
tintifaxl Posted November 30, 2016 Posted November 30, 2016 I'm using the Logitech profiling software without any problems in DCS. Did you activate the correct profile on the keyboard when running DCS? Windows 10 64bit, Intel i9-9900@5Ghz, 32 Gig RAM, MSI RTX 3080 TI, 2 TB SSD, 43" 2160p@1440p monitor.
Abburo Posted November 30, 2016 Posted November 30, 2016 Try "run as administrator" for Logitech software. If this not solve your issue then add small latency between strokes within macros. Romanian Community for DCS World HW Specs: AMD 7900X, 64GB RAM, RTX 4090, HOTAS Virpil, MFG, CLS-E, custom
Zooker Posted November 30, 2016 Author Posted November 30, 2016 @tintifaxl - the profile is activated. It's a 3 part keystroke, that might be an issue. @Abbury - Thanks! I will give that try. VF-111 Sundowners [sIGPIC][/sIGPIC] Carrier Group 1 - Battlegroup Delta Beware the lessons of a fighter pilot who would rather fly a slide rule than kick your ass! -Commander Ron "Mugs" McKeown, USN Commander, U.S. Navy Fighter Weapons School 2 Victories, Vietnam
Recommended Posts