Ramstein Posted February 3, 2017 Posted February 3, 2017 When I install the fuel tank , centerline, AJS-37 is totally untrimable. The plane just goes totally out of control... it will not fly straight and is out of control. What happened? :helpsmilie: :joystick: ASUS Strix Z790-H, i9-13900, WartHog HOTAS and MFG Crosswind G.Skill 64 GB Ram, 2TB SSD EVGA Nvidia RTX 2080-TI (trying to hang on for a bit longer) 55" Sony OLED TV, Oculus VR
razo+r Posted February 3, 2017 Posted February 3, 2017 When I install the fuel tank , centerline, AJS-37 is totally untrimable. The plane just goes totally out of control... it will not fly straight and is out of control. What happened? :helpsmilie: :joystick: Give us more infos or give us a track Like speed?
Ramstein Posted February 3, 2017 Author Posted February 3, 2017 not much to see... it just goes out of control and crashes.... or you get lucky and spin around and upside down a few more seconds before crashing.. ASUS Strix Z790-H, i9-13900, WartHog HOTAS and MFG Crosswind G.Skill 64 GB Ram, 2TB SSD EVGA Nvidia RTX 2080-TI (trying to hang on for a bit longer) 55" Sony OLED TV, Oculus VR
razo+r Posted February 3, 2017 Posted February 3, 2017 speed? altitude? payload? wind? attitude? best thing would be that you give us a track and more infos
Ramstein Posted February 3, 2017 Author Posted February 3, 2017 Track of trim gone bad. It is possible the Saitek stick is sending bad inputs. I try cancelling out trim with the O key, in the control panel it says use that key to cancel trim. I used an instant mission, it cut the time and get to the issue without a full mission with takeoff... as you can see it happen well after the start... I don't have problems until I try to add any type of trim. Then go back to no trim to cancel out and go back to neutral. Also, I try setting the Autopilot button on top left cockpit to see if that will take over and smooth out the ride. But it just turns those off as it gets worse until it is totally out of control. It starts going bad quickly while flying. :joystick:DCS_Viggen_Track_Trim_Gone_Bad.zip ASUS Strix Z790-H, i9-13900, WartHog HOTAS and MFG Crosswind G.Skill 64 GB Ram, 2TB SSD EVGA Nvidia RTX 2080-TI (trying to hang on for a bit longer) 55" Sony OLED TV, Oculus VR
Ramstein Posted February 4, 2017 Author Posted February 4, 2017 note that I have no control problems when I don't use the outside fuel tank :joystick: ASUS Strix Z790-H, i9-13900, WartHog HOTAS and MFG Crosswind G.Skill 64 GB Ram, 2TB SSD EVGA Nvidia RTX 2080-TI (trying to hang on for a bit longer) 55" Sony OLED TV, Oculus VR
Ramstein Posted February 7, 2017 Author Posted February 7, 2017 I did add a flat spot on the rudder, so there is no input of any kind for about 10% of the middle for the rudder.. I think I was getting erroneous inputs causing the rudder to move around.. ASUS Strix Z790-H, i9-13900, WartHog HOTAS and MFG Crosswind G.Skill 64 GB Ram, 2TB SSD EVGA Nvidia RTX 2080-TI (trying to hang on for a bit longer) 55" Sony OLED TV, Oculus VR
outbaxx Posted February 7, 2017 Posted February 7, 2017 I haven't flown without the external fuel tank yet so I can't compare but I haven't had any issues with the trim during flight and I have been using the trim a lot.
Sealord Posted October 1, 2017 Posted October 1, 2017 AJS Viggen Trim not works Hi, the same Problem here both Joystick and Keyboard keys don´t work. I can´t trim teh Viggen. Other Moduls like F-5E and SU-25 works correctly with teh Input by teh Joystick. AMD Graphic Cards Radeon HD 7800 Intel i-7 3.40 GHZ G.Skill DDR3 ram 16 GB 46" Samsung LCD HDTV Win10 pro x64 Thrustmaster T16000, TWS Throttle, Thrustmaster Pedals
Hog_No32 Posted October 3, 2017 Posted October 3, 2017 Ramstein, so you are talking about the rudder trim (yaw) and not the pitch trim? Quite an important ‚detail‘ since there are different trimming systems. I‘m using the external tank on almost every flight and never had any such issues. I‘m using TM Warthog and version 1.5.7 most of the time.
goestrip Posted October 3, 2017 Posted October 3, 2017 I noticed the pitch trim is quite slow to respond. but engaging the altitude usually trims the plane just fine so when you remove the AP, it's stable
Recommended Posts