Jump to content

Recommended Posts

Posted

I have a TM HOTAS set up with TFRP rudders. I have a dead zone on both the stick and the rudders. I have also calibrated all controllers. I am flying the F-15C and flying the preloaded missions that comes with the module.

 

Is this an issue of a crosswind? I am thinking its not because it begins early in the roll on take off. Does anyone have any ideas?

 

Thanks!

Posted

Check the other columns in the control setup (after the upgrade). It's possible that you have an overlap in assignment.

hsb

HW Spec in Spoiler

---

 

i7-10700K Direct-To-Die/OC'ed to 5.1GHz, MSI Z490 MB, 32GB DDR4 3200MHz, EVGA 2080 Ti FTW3, NVMe+SSD, Win 10 x64 Pro, MFG, Warthog, TM MFDs, Komodo Huey set, Rverbe G1

 

Posted

I created a mission with zero wind and it did the same thing. I also checked to make sure I didn't have duplicate inputs. That's not the issue either. I am wondering if it is a calibration issue? I am going to delete the inputs for the rudder to eliminate that as an issue.

 

 

Sent from my iPhone using Tapatalk

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...