Time On Target w Mach input don't work.

[CoBlue]

Latest (1.5.7). ToT (Time On Target) is way off.

When inputting Mach speed, according to manual, the "fin" & time deviation on CK commands very low speed (≈M.06). Tested M0.75/80/85/90 on several WP's & ingress/egress points.

The (-) sign is missing when in TID if ToT is set.

Commanded speed is not 550km/h to B1 & B2 (it's ≈400km/h).

When not imputing ToT, Target-WP shows 700000 instead of flight time.

 

ToT works if you follow the (fin) or time deviation on CK, but the speeds are very low & can't be practically used in an attack mission.

 

Exactly the same problem described here:https://forums.eagle.ru/showpost.php?p=3038754&postcount=2

Edited July 15, 2017 by CoBlue

[whaaw]

after testing it again DCS 1.5.7 the viggen wants to fly 400km/h no matter wat you set machspeed for the first target.

[Fishbreath]

This appears to be an issue with CK37 input, rather than the TOT calculations per se. The Viggen dynamic campaign has reasonable ingress speeds as part of the mission plan.

[whaaw]

This appears to be an issue with CK37 input, rather than the TOT calculations per se. The Viggen dynamic campaign has reasonable ingress speeds as part of the mission plan.

 

i did not have problems to set up ingress speed or ToT its just for the first target point when stationarry on the ground.

 

how to replicate. set up 1 target point, make a coldstart input machspeed you want to fly, wait until takeoff time 0, take off. your speed 400km/h. no matter waht you inputed for first target point

[CoBlue]

From 2.5 changelog: "Fixes to Time On Target calculation accuracy".

 

TOT is still not working as in the manual.