do not stop on ground

[LADYDI]

Good evening people, I look for someone who can help me in this. When you land the MI-8M anywhere you put the brakes suddenly start rolling back touching the tail on the floor without stopping. It stops at the moment that I control it with the joystick pushing it forward, until it is leveled but I have to stay with the control forward because otherwise it starts to roll back again. I have checked the controls but I do not see anything that solves it or at least there is something I do not know, I will thank someone who can help me with this, thank you.

[Esac_mirmidon]

Did you try to reset the trimmers?

 

Depending on your landing attitude and the trim you´ve used to reduce speed ( low tail attitude, high nose ), if you keep the same attitude trim on the ground the MI-8 will try to keep the tail low, and the nose high.

 

So while on the ground try reset the trim and engaging the parking brakes.

[LADYDI]

thank you Esac mirmidon, buy how can i do for reset the trim?

[Esac_mirmidon]

In the center panel, AFCS panel you can reset the trim.

 

Or take a look into the keybindings in the controls tab.

[Art-J]

I think one cannot reset the trim on the central panel, but there is a reset/disengage command in the controls (corresponding to one of the buttons on the pilot's stick), so I would assign that one.

 

First and foremost, however, I would start with posting the question in more relevant section of the forum (general Mi-8 sub-forum). Skinning section is the last place where one would expect finding threads about aircraft controls ;).

[Esac_mirmidon]

You are right. The reset trim is in the Cyclic.