SA identification

[SirJ]

Hey guys,

 

 

I have a small mission set up with a C2 and a few red fighter in a flight of 4.

 

 

The contacts are ID'ed as enemy from the C2 (lower part of the chevron) and unk from my ID (upper part).

 

 

How can I ID them by myself?

 

Which button do I have to use to use NTCR?

Even with lock on one fighter 3 symbols turn red (with a form which is not in Watt's video)...see pic 2

 

when lost from radar (i came in quite close...) the contacts became red with this small bodies...see pic 3

 

best regards

Edited March 3, 2019 by SirJ

[Py]

Watch Wags' video again carefully and it makes sense what you are seeing.

 

To do manual IFF you need to put the cursor over them on the radar page and press sensor select depress, which you might not have bound yet so check it.

 

The small diamonds mean hostile from a surveillance sensor and no information from your own sensors.

So when you are tracking one target with STT in pic 2, your radar can't see the other 3 targets so they are shown from SURV data only.

When not on your radar in pic 3 they are all from SURV data only.

[SirJ]

Sensor select depress != TDC depess...makes sense :doh:

 

Thank you very much for clarification :thumbup:

[Blindman]

Sensor select depress != TDC depess...makes sense :doh:

 

Thank you very much for clarification :thumbup:

 

Tdc depress Is not the same as sensor select depress. The latter One Is a new keybind

[Eaglewings]

Tdc depress Is not the same as sensor select depress. The latter One Is a new keybind

Yes Sensor Select Depress is different from TDC depress. You can search keymapping control section with sensor.

You will find sensor cursor switch depress unmapped. That is the new interrogation switch. Map this to your preferred hotas.