TDC Controller slightly left drag

[memoric]

Hello

 

 

I encountered a bug, and don't think it applys to my controll settings.

 

 

On the Radar Page, and on the SA Page the TDC Controller, when selected (diamond top right) has a slightly left drag when i'm not doing anything, not touching the controller. It's really annoying to correct this all 3-4 secs.

 

 

 

Anybody else gets this?

 

 

In the axis calibration in the controlls menu, the axis is centered, so either I have a Bug in my HOTAS Software (don't know how to center the Button there) or it's in the game.

 

 

Thank you for reading

 

 

regards

[rob10]

I have a CH PRO throttle and the mini-joystick on it that I use for TDC will often have a bit of a phantom input that causes it to wander slowly in one direction or another. After I stop it, it stays put, but it doesn't like to perfectly centre itself on release. Maybe I could just add a bit of deadzone, but it hasn't risen to that level of annoyance yet.

So it's possible that it's something in the game, but good odds that it's your controller. This doesn't seem to be an uncommon issue with controllers.

[cthulhu68]

I have the Ch throttle too and always add a little deadzone to ministick x-axis (8-10) and also add a smaller deadzone to y-axis (5) so it feels the same in both directions. Mine usually just wants to drift to the right but this works prett well.

[Rennes]

I have the WH throttle and stick. I often find my TDC cursor in the upper left corner, but I've always assumed I've put it there over time by hitting the mini stick on accident every once in a while.

[whaaw]

I have the WH throttle and stick. I often find my TDC cursor in the upper left corner, but I've always assumed I've put it there over time by hitting the mini stick on accident every once in a while.

 

i think upper left corner is default for the cursor after startup :)

 

Also make sure ther is no other controler on your system OP. I once had the same problem, turns out my xboxcontroler was on...:D

[98abaile]

Most likely to be whatever you use as your TDC. Before I replaced it, I had a similar issue with the mouse nipple on my TMWH. Not only was it biased to one side, it would never return fully to center.