Gierasimov Posted February 27, 2020 Posted February 27, 2020 I am leaning the ropes of Ka-50, I setup a quick hot parking start mission. Each time I press trimmer (T) the Desired Track Angle (DTA) pointer on HSI changes position. As soon as I reset trimmer, it does the same. I tried to check in the manual but could not understand why is that. Why? Intel Ultra 9 285K :: ROG STRIX Z890-A GAMING WIFI :: Kingston Fury 64GB :: MSI RTX 4080 Gaming X Trio :: VKB Gunfighter MK.III MCG Ultimate :: VPC MongoosT-50 CM3 :: non-VR :: single player :: open beta
AvroLanc Posted February 27, 2020 Posted February 27, 2020 I am leaning the ropes of Ka-50, I setup a quick hot parking start mission. Each time I press trimmer (T) the Desired Track Angle (DTA) pointer on HSI changes position. As soon as I reset trimmer, it does the same. I tried to check in the manual but could not understand why is that. Why? This will happen if you’ve either got no navigation (waypoint, airfield, fiixpoint, or target) point selected or have the DH/DT switch set to the middle position. The trimmer command will set the current heading as the steering command in this situation.
Gierasimov Posted February 27, 2020 Author Posted February 27, 2020 Thanks! Intel Ultra 9 285K :: ROG STRIX Z890-A GAMING WIFI :: Kingston Fury 64GB :: MSI RTX 4080 Gaming X Trio :: VKB Gunfighter MK.III MCG Ultimate :: VPC MongoosT-50 CM3 :: non-VR :: single player :: open beta
Recommended Posts