FoxTrotAlpha691 Posted April 16, 2020 Posted April 16, 2020 Since the last update I am no longer able to see moving ground targets with the GMTI radar mode. Before when I set the elevation carat to 0 it would center and now it is very far up the scale into the positive area but still reads as 0 and does not move to the center position on the elevation scale. In the pic below the left side is before the update and the right side is after the update. Can anyone advise if they are seeing this issue as well or am I still missing something with the ATG radar operation?
J20Stronk Posted April 16, 2020 Posted April 16, 2020 I think it's been fixed this update, but if it hasn't you can switch to AA mode, wait for the antenna to come down, then switch back to AG. It should now be pointing where you want it to.
FoxTrotAlpha691 Posted April 16, 2020 Author Posted April 16, 2020 I think it's been fixed this update, but if it hasn't you can switch to AA mode, wait for the antenna to come down, then switch back to AG. It should now be pointing where you want it to. Thanks for the response, I did see they addressed this in the update, just downloaded it so I will test it now. Salute!
J20Stronk Posted April 16, 2020 Posted April 16, 2020 Thanks for the response, I did see they addressed this in the update, just downloaded it so I will test it now. Salute! Yep, looks like it was fixed. Thanks Deka!
foxwxl Posted April 17, 2020 Posted April 17, 2020 Best to use the AG radar with a SLV point around the target site. Or U can manual TDC depress on rdr near where U think the target would be. All these 2 methods above will point the radar antenna to the correct elevation. Deka Ironwork Tester Team
Recommended Posts