TAW_Impalor Posted May 31, 2020 Posted May 31, 2020 (edited) Hello. Some clickable controls are only enabled for joysticks. What is the reason for that? I use Warthog TARGET for everything, and not being able to map it is annoying. Edited May 31, 2020 by impalor 12900KF@5.4, 32GB DDR4@4000cl14g1, 4090, M.2, W10 Pro, Warthog HOTAS, ButtKicker, Reverb G2/OpenXR
Harker Posted June 1, 2020 Posted June 1, 2020 The "Special for joystick" commands work with YES/NO states. As long as the switch is held/key is pressed, DCS will stay on YES. When the switch/key is released, it'll revert to NO. You can use the separate ON and OFF commands to control it through the keyboard. The vCVW-17 is looking for Hornet and Tomcat pilots and RIOs. Join the vCVW-17 Discord. F/A-18C, F-15E, AV-8B, F-16C, JF-17, A-10C/CII, M-2000C, F-14, AH-64D, BS2, UH-1H, P-51D, Sptifire, FC3 - i9-13900K, 64GB @6400MHz RAM, 4090 Strix OC, Samsung 990 Pro
TAW_Impalor Posted June 1, 2020 Author Posted June 1, 2020 (edited) Huh? I know I can use ON and OFF separately, and I did just that in the screen attached, but it takes two bindings instead of one (and occupies two buttons/switch positions on my physical HOTAS). The switch in question - KY58 Power Select does not need to be held in RL. I can bind gear up/down to a single button, but not this switch? Just does not make any sense to me... Edited June 1, 2020 by impalor 12900KF@5.4, 32GB DDR4@4000cl14g1, 4090, M.2, W10 Pro, Warthog HOTAS, ButtKicker, Reverb G2/OpenXR
ED Team cofcorpse Posted June 1, 2020 ED Team Posted June 1, 2020 As you might have noticed, this switich has 3 positions. There is no command to switch between them all. You have commands to cycle it clockwise (CW) and counterclockwise (CCW). Or you can use commands for each position. Input command under 'Special for joystick' category are not meant to be used with keyboard, because in order to make them work you have to keep button pressed all the time. If I didn't answer your question, please, explain a bit more. Thanks!
Fusedspine33 Posted June 17, 2020 Posted June 17, 2020 Have you tried without target? The command assignment page works with your warthog natively. In the case you have highlighted, one of the toggle switches on your warthog that only electronically activates one way (on) and has no electronic signal for (off) can be used. Find your warthog in the columns and double click on it bringing up the sub menu, activate the switch and save your profile under a custom name so DCS doesn’t overwrite during an update. The highlighted key bind will allow you to use those “dumb” on-off toggles as on-off in the software. Sent from my iPad using Tapatalk
Recommended Posts