Gear and Hook - have to flick twice?

[GunSlingerAUS]

I'm using the VPC MongoosT-50CM2 Throttle, but had the same issue with my Warthog - I have assigned a switch (which only registers as a single button press when flicked up, but no button press when in the down position) to gears up, otherwise extended. But when I flick the switch down, my gear stays up. I flick it back up, then down again, and this time it works. Happens every time, and also happens with my hook assignment.

 

Any idea how to fix this?

[pokeraccio]

Hi, you should map the VPC throttle “switch down position” to a button in VPC software, then you can assign/bind the new button in DCS control config.

 

As the “switch down position” was not mapped in VPC software, to any button by default.

 

Note: Be careful to operate the VPC software, at the beginning I did some mess and just once I messed up all my previous button config, but was my mistake, and fixed it by reassign all the button to DCS again, nothing shocking.

 

 

Sent from my iPhone using Tapatalk

[rob10]

If Pokeraccio suggestion doesn't work (or for a Thrustmaster) you will need to play with the .lau files (pretty easy) to make it work both ways. See the sticky (the toggle switch one) at the top of the input/output subforum or do a search.

Edited August 3, 2020 by rob10

[HC_Official]

check my sig for tutorials on how to configure virpil kit

[GunSlingerAUS]

Brilliant, thanks guys. HC_Offic, can I ask which of your many, many thorough tutorials shows how to: " map the VPC throttle “switch down position” to a button in VPC software, then you can assign/bind the new button in DCS control config." ?

[HC_Official]

in button tab, toggle with switch up n down, then note down which physical buttons get hit (eg 30 and 31)

 

locate the one already bound, change its type to TOGGLE ON (maybe 30 physical or 31)

 

then go to first free space at bottom list and create a new binding on TOGGLE ON for the one not bound, SAVE VPC DEVICE