dresoccer4 Posted October 17, 2020 Posted October 17, 2020 hey guys, probably a dumb question, but i followed chuck's start up guide, however the FCS 1 and FCS 2 lights are still other warning panel. how do i ge those off? Acer Predator Triton 700 || i7-7700HQ || 512GB SSD || 32GB RAM || GTX1080 Max-Q || FFB II and Thrustmaster TWCS Throttle || All DCS Modules
paco2002 Posted October 17, 2020 Posted October 17, 2020 hey guys, probably a dumb question, but i followed chuck's start up guide, however the FCS 1 and FCS 2 lights are still other warning panel. how do i ge those off? I never had that issue, but I guess that if you press the Reset button in the FCS panel that would solve it
Tiger-II Posted October 21, 2020 Posted October 21, 2020 Check the switches on the FCS panel left side, just above the standby radio panel. If they are set correctly, hit the RESET button. Also, make sure you have the AC and DC gens ON (elec panel, next to the battery switch), and the engine generator is selected ON (left side, by the throttle). Motorola 68000 | 1 Mb | Debug port "When performing a forced landing, fly the aircraft as far into the crash as possible." - Bob Hoover. The JF-17 is not better than the F-16; it's different. It's how you fly that counts. "An average aircraft with a skilled pilot, will out-perform the superior aircraft with an average pilot."
Zergburger Posted October 30, 2020 Posted October 30, 2020 i bet he either waited too long to turn on the bleed air cooling and they overheated or he didn't turn on the bleed air at all. this will cause all kinds of problems with the electronics in the plane
Recommended Posts