Mission #14 no comms or briefing

[SharpeXB]

I’m not getting any comms or briefing. I’m on package and mission freqs

[baltic_dragon]

Hey, just checked it - works fine for me. Berger will initiate it 60s after mission start, best ask for Ground Power and set radios to CH1 on red and 3 on Green. Let me know if it helps!

 

EDIT - sorry, ran M15. For M14 all works well for me to. Just to be on a safe side run the ground power on mission start. Check in on CH1 red, then brief 5m later on CH2 red. 

Edited January 2, 2021 by baltic_dragon

[SharpeXB]

I hear “briefing on Package over Sally” so I’m on the Package frequency right after the initial check on Red and Green channels 1. But I don’t get any further comms. After takeoff I switch from Package & Departure to Package and Main Mission but again I don’t get anything. After the startup check I’m on Package continually. 

[SharpeXB]

PS I’m not sure how to make this work. 
First I’m on channels R1 and G1 for the initial. Then on Red: Package / Green: ATIS- Ground-Tower-Departure-Main Mission. But I get no radio comms. No briefing on Package over Sally

[baltic_dragon]

OK, to make sure I understand correctly: you don't get any comms after you take off, so the briefings on the ground work as intended, right? 

[pieroboy99]

Your problem i s not on the ground but once over sally as i understand.

I just made it and there's no problem, you have to sadle with the package and once done monitor CHANNEL2 on RED and 8(Mission) on GREEN....not sally which is 6.

The channels are listed on your kneeboard

I think it was the problem.

Cheers 

Edited January 7, 2021 by pieroboy99

[SharpeXB]

I just tried it again and no luck. I'm on Mission and Package freqs 

Is the problem that I'm not in formation with the flight? But as far as I can tell I'm on the right channels

[SharpeXB]

I got it. I wasn’t close enough to the flight to get the message.