VAICOM stopped working

[sirrah]

I'm starting to get to a point where I think VAICOM and me are just not made for each other... 

 

For some reason VAICOM completely stopped working...

 

I recently purchased the realistic ATC extension.

So here's what I did;

• I successfully validated/activated my key
• Opened the VAICOM editor tab and pressed "finished"
• Opened the VoiceAttack settings (the little pencil icon), went to the "When I say:" line and pressed ctrl-v

 

I flew one or two missions and noticed that my VAICOM interactive kneeboard extension stopped respond properly (it worked just fine before). It did open, but it didn't open the various tabs (e.g.: Flight, AWACS, Tower, Anvil, etc.). For the rest, VAICOM was working well. My flight members, AWACS, Supercarrier, etc. were all responding like they should.

 

Today I tried again, and now nothing is working anymore...

My kneeboard won't open, none of the ATC are working... nothing... 

I do hear the VAICOM beeps that my voice input is recognized and I triple checked my radio freqs, but no responses.

I tried exactly the same mission as yesterday, containing only me and a supercarrier. Yesterday all was fine and today, without changing anything, when I say "marking moms" I see this in my VA log:

 

 

 

I already did a DCS repair

Removed the export.lua

Restarted everything (VA, VAICOM, DCS, heck... my entire pc..)

 

What could be happening here?

 

 

 

 

 

Edit:

Just gave it yet another shot and rebooted my pc and tested VAICOM in DCS. This time my comms were working and my kneeboard opened again. However my kneeboard tabs were still not responding to my Anvil, AWACS, Flight, Tower, etc. calls

Edited February 6, 2021 by sirrah

[hornblower793]

Sirrah - do you have autobrowse turned on in the Vaicom options? If not, you will need to say Anvil...Page, Tower...Page etc

[Drac]

Sirrah - Looks like you did not complete the "Finish" process...at least from the steps you stated.

[sirrah]

8 hours ago, hornblower793 said:

Sirrah - do you have autobrowse turned on in the Vaicom options? If not, you will need to say Anvil...Page, Tower...Page etc

This is probably what's going on. I'll confirm here once I get a chance to test it.

 

Thanks