new interface coming Setting Laser Code on bombs to something other than 1688

[Ridley_Dog]

I did a search and am trying to figure out if they have added the feature where you can change the Bomb's laser code i the F16.  I have seen a few things where it says it is not a feature yet in the F16 and you should set it in the Mission Editor with the code you want.  Once in jet you set the new code from the DED to match

 

So just wanted to make sure I am not missing the steps that may have been added by now where while you are in the jet that you can change the code on the bombs themselves to something other than 1688 and then update code match in the DED

 

[Falconeer]

You can set it in the kneeboard while you are on the ground. (R-shift + K) I think the engine needs to be off too iirc

 

After that you need to change the code with use of the ICP to match the one you set on the bombs. There is no way in the F16 to change the bombs code inflight 

[Ridley_Dog]

So that is right shift = right ALT keypad 9

Works thanks.

 

Now I have to figure out how to get the kneeboard to show up on my main monitor since I use 3 8" lilpads

[Mustang25]

3 hours ago, jd4macgaw said:

 

Now I have to figure out how to get the kneeboard to show up on my main monitor since I use 3 8" lilpads

 

You can just click and drag them or use Kneeboard Builder and it'll set it in whatever spot you want every time.

[Florence201]

Whatever you set pre start in the kneeboard, be sure to set in the Laser DED page too

[Kaitsu]

Is this broken now? I set the LGB code to 1686 on mission editor and 1686 on TGP and bombs won't guide to the lased target.

 

F-16 TGP LGB test.miz

[LorenLuke]

On 11/29/2023 at 2:57 PM, Kaitsu said:

Is this broken now? I set the LGB code to 1686 on mission editor and 1686 on TGP and bombs won't guide to the lased target.

 

F-16 TGP LGB test.miz 20.76 kB · 7 downloads

Only Tail# 010 has bombs set to 1686. 

F16 LGB.trk