Jump to content

Question about fuel pumps on startup.


Aernov

Recommended Posts

Is MiG-21 supposed to start and run it's engine with fuel pump switches off? Real procedure requires (or advises?) at least feed tank pump on before engaging starter, with enabling two other pump switches soon after engine idle RPM stabilization and AC generator becoming operational, in DCS engine can start and operate with all pumps off.

  • Like 1
Link to comment
Share on other sites

Yes it is possible, I know even a story of a student performing one of his first solo flights with fuel pumps disengaged, where he wondered why the empty tanks lights were blinking during pattern flight in turns even though the fuel tanks were full. Only after landing he realized that fuel pumps were off when switching the engine off. It wasn't however Bis version, but the fuel system is nearly the same.

  • Like 2
Link to comment
Share on other sites

16 hours ago, Aernov said:

Is MiG-21 supposed to start and run it's engine with fuel pump switches off?

I'm no Mig-21 expert, it's been a while since i read the manuals, but from what i remember the fuel pumps are "just" used to manage correct fuel flow from the tanks to the engine in situations gravity is not enough. From the Mig-21bis flight operations instruction, you turn on the fuel pumps after engine start:

 

1.jpg

  • Like 4

Modules: KA-50, A-10C, FC3, UH-1H, MI-8MTV2, CA, MIG-21bis, FW-190D9, Bf-109K4, F-86F, MIG-15bis, M-2000C, SA342 Gazelle, AJS-37 Viggen, F/A-18C, F-14, C-101, FW-190A8, F-16C, F-5E, JF-17, SC, Mi-24P Hind, AH-64D Apache, Mirage F1, F-4E Phantom II

System: Win 11 Pro 64bit, Ryzen 3800X, 32gb RAM DDR4-3200, PowerColor Radeon RX 6900XT Red Devil ,1 x Samsung SSD 970 EVO Plus 2TB NVMe, 2 x Samsung SSD 2TB + 1TB SATA, MFG Crosswind Rudder Pedals - VIRPIL T-50CM and VIRPIL MongoosT-50 Throttle - HP Reverg G2, using only the latest Open Beta, DCS settings

 

Link to comment
Share on other sites

Engine pulls fuel by mechanical pump. Switches are for electrical pumps. Officially I think supposed to run dispenser tank during start and add rest later. It might vary with without external power. In DCS battery power can run out but never an issue running all 3 anyway.

  • Like 1
Link to comment
Share on other sites

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...