Steel Jaw Posted March 21, 2021 Posted March 21, 2021 (1) What is the correct key bind when I physically move the throttles from off to idle? (2) What is the correct key bind for the flaps lever to move from auto>half>full? (In the Hawg it already works this way by default). Thanks folks. "You see, IronHand is my thing" My specs: W10 Pro, I5/11600K o/c to 4800 @1.32v, 64 GB 3200 XML RAM, Red Dragon 7800XT/16GB, monitor: GIGABYTE M32QC 32" (31.5" Viewable) QHD 2560 x 1440 (2K) 165Hz.
Lange_666 Posted March 21, 2021 Posted March 21, 2021 1: No clue, i don't use detents. 2: That doesn't always work out of the box (except in the Hawg) because you only have two positions (up/down), not three (middle does not really exist, it's the off state for both others). I don't know about the T.A.R.G.E.T. GUI but in Targetscripteditor you can program a key release (from flaps up to middle for example) and then you can make it work. 1 Win11 Pro 64-bit, Ryzen 5800X3D, Corsair H115i, Gigabyte X570S UD, EVGA 3080Ti XC3 Ultra 12GB, 64 GB DDR4 G.Skill 3600. Monitors: LG 27GL850-B27 2560x1440 + Samsung SyncMaster 2443 1920x1200, HOTAS: Warthog with Virpil WarBRD base, MFG Crosswind pedals, TrackIR4, Rift-S, Elgato Streamdeck XL. Personal Wish List: A6 Intruder, Vietnam theater, decent ATC module, better VR performance!
VpR81 Posted March 21, 2021 Posted March 21, 2021 Don't have the Warthog Throttle anymore, but i believe to remember both of your requests beeing only possible via Target GUI. But via Target GUI it definately works, the 3 Flaps positions as well as Idle/Cutoff on the throttle. cheers Phanteks EvolvX / Win 11 / i9 12900K / MSI Z690 Carbon / MSI Suprim RTX 3090 / 64GB G.Skill Trident Z DDR5-6000 / 1TB PCIe 4.0 NVMe SSD / 2TB PCIe 3.0 NVMe SSD / 2TB SATA SSD / 1TB SATA SSD / Alphacool Eisbaer Aurora Pro 360 / beQuiet StraightPower 1200W RSEAT S1 / VPC T50 CM2 + 300mm extension + Realsimulator F18 CGRH / VPC WarBRD + TM Warthog grip / WinWing F/A-18 Super Taurus + F-15EX / 4x TM Cougar MFD / Slaw Device RX Viper V3 / HP Reverb G2
rob10 Posted March 21, 2021 Posted March 21, 2021 3 hours ago, Mower said: (1) What is the correct key bind when I physically move the throttles from off to idle? (2) What is the correct key bind for the flaps lever to move from auto>half>full? (In the Hawg it already works this way by default). Thanks folks. What aircraft? In the F-18 it's as simple as FLAP Switch - AUTO/HALF, and FLAP Switch - FULL/HALF (both are under "Special for Joystick" category), and Throttle (Left or right) - OFF/IDLE 1
Recommended Posts