Jump to content

Recommended Posts

Posted (edited)

Which setting is this rotary switch currently set to?

AC Voltmeter.png

 

Most of the switch positions for the AC selector do not coincide with the placard.

 

Regarding the DC selector switch. Some of this is an improvement request, some of this is lack of understanding and system description still being WIP:

DC Voltmeter.png

 

I don't get the difference between BATTERY and BATTERY BUS I/II.

Turning on either battery will provide voltage to all 3 switch positions, even with no other switches turned on. With both batteries OFF, all 3 positions show 0V. In the MI-8 there are two positions to independently check the batteries, even when they are turned off. Is that the purpose of BATT BUS 1 &2? Just seems weird to have 3 positions that do the exact same thing....

 

Also It's hard to understand this knob because the dividing lines between I & II are a little too tall. I didn't realize what I was looking at until I referenced another source. If the vertical line between AKKUM SHINY I and II was a little shorter, I could tell that the words AKKUM SHINY apply to both.


Compare the readability to here:

Mi24v_power_supplies.png

From: http://eechcentral.simhq.com/index.php?title=Mi-24V_Flight_Manual_part_1#1.1_Preliminary_Cockpit_Inspection

 

TRACK IS ATTACHED

 

Thank you!

Hind Electrical bugs.trk

Edited by randomTOTEN
Guest
This topic is now closed to further replies.
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...