can not reproduce Designating a Ground Target Track Changes TOO Coordinates for JDAMs

[Cepheus76]

Hello all,

Until recently I could find TOOs for JDAMs using the radar, placing the cursor on top of a target, and then designating the target. The coordinates generated and sent to the JDAM were spot on and I enjoyed a high hit probability. 

However, when I tried the same procedure yesterday, after being away from DCS for a couple of weeks, I found that after designating the target with the radar, the coordinates previously generated when placing the cursor on the target are replaced by a new set, which is quite a bit off. 

Is this new behaviour intended or am I missing something else?

Best regards,

Cepheus

Designating Ground Target Track Changes TOO Coordinates.trk

[BIGNEWY]

Hi, 

I have tested this today and I am not seeing a problem, I setup 4 targets and using exp3 and radar only I got 3 kills and a 50% damage hit on the forth target using TOO mode. 

[Cepheus76]

Okay, I'll try again. Thanks for the feedback!