reported Crus Page: increasing/decreasing active STPT equals increasing/decreasing HMPT

[Rubberduck85]

Hello Devs,

I kindly ask you to re-open this bug report (opened by me).

It was marked as fixed and indeed there was an improvement: when in Crus->Home interacting with the rocker to change the HMPT now does not change "active" STPT (thanks!).

However i've found this: airstart, flight plan of 3 STPTs (#3 being the landing airbase) if I go to Crus->Home and change the HMPT to #3 it does not change the active STPT (correct behaviour).

But when I exit Crus->Home, reach STPT #1 and switch to STPT#2, when i go back to Crus->Home the HMPT is now #4. Again if i exit and change active STPT (#2->#3) when i go back to Crus->Home it will now be #5.

Apparently if I change the HMPT and exit the Crus->Home page, every increase (or decrease) I make to active STPT will be reflected to the HMPT, but this should not happen, HMPT should remain what i set it to be indipendently from what i select as active STPT in navigation. 

This bug does not occur if i leave HMPT unchanged, only if I interact with the sub-page and change it to something different from #1

Track attached.

Same behaviour with cold and dark start but track was too large.

Regards

 

F-16_CRUS_HMPT_BUG.trk

 

 

Edited November 6, 2022 by Rubberduck85

[BIGNEWY]

Hi, 

reproduced and reported

thank you

[BIGNEWY]

fixed for next patch