FORCE TRIM Relese

[pac]

I have problem with force trim relase, they button works in ........ I see red corssing but it do not effect to heli,

[Floyd1212]

Not a whole lot to go on there, but maybe something similar to this?

https://forum.dcs.world/topic/311239-force-trim-not-holding-for-cyclic/

 

[pac]

I coudnt edit or delete my previous post ....by mistake I sent not finished post.
Bellowe more infomations about issiue.
I have problem with force trim release R, the button works because when I push trim release R button in "right CTRL+enter" screen I see red cross immediately but it do not effect to heli. I adjusted specif setting to central and instant, no effect.

I bought Apache few day ago maybe it is something obvious. I checked manual and other topicssa but nobody had same issue, theoretically you push hat and it should be trimmed. What is strange both Force Trim Altitude  R/L buttons works. 

[Floyd1212]

Can you post some screenshots of your controls indicator when it isn't working?

Are you saying the red X will stay where you intended when you press and release the Force Trim Release button, but then when you let go of your joystick the white diamond returns to center?

[pac]

Screenshot:

 

I watched this

 tutorial and in my case it looks same but no effect.  No matter which setting I will choice (central/instant) in axes indicator screen appears red cross which should mean that trimming works but when I will take hands from stick heli behave like they would not be trimed (I know that in central setting the new trimmed position of stick will only be applied after the stick is returned to neutral position)

[pac]

54 minutes ago, Floyd1212 said:

Not a whole lot to go on there, but maybe something similar to this?

https://forum.dcs.world/topic/311239-force-trim-not-holding-for-cyclic/

 

Thanks for those tips, when I will back home will try to repair game or  will install it again, I have same problems.

[Tholozor]

@pac Make sure you have Game Mode disabled in the DCS Options. I'm not seeing green SCAS indicators or SCAS authority zone boxes on your control overlay.

[Swift.]

13 hours ago, pac said:

I coudnt edit or delete my previous post ....by mistake I sent not finished post.
Bellowe more infomations about issiue.
I have problem with force trim release R, the button works because when I push trim release R button in "right CTRL+enter" screen I see red cross immediately but it do not effect to heli. I adjusted specif setting to central and instant, no effect.

I bought Apache few day ago maybe it is something obvious. I checked manual and other topicssa but nobody had same issue, theoretically you push hat and it should be trimmed. What is strange both Force Trim Altitude  R/L buttons works. 

Would you be able to check you don't have force feedback enabled. It's under misc or general settings iirc.

[pac]

@Tholozor honestly speaking it is not screenshot directly from my pc. I have those green indicators. Game mode is disabled for sure. 

@Swift. sounds promising! Will check it tomorrow.

 

[pac]

@Swift. I have also Huey module and also I couldn't set trim. But with huey this issue wasn't so important, I used to use autopilot. WIth Apache is different story.