questions about MASTER TEST

[Evg85]

Hi all! I am studying the F-14 module and during the start-up procedure of this aircraft, I had a question.

When performing an emergency generator test, NO GO light should illuminate for about 1 sec before GO light illuminations. But in my case nothing lights up. I waited over a minute - to no avail.

Same with VMCU verification procedure. Following disengagement of MASTER TEST -EMERG GEN the following lights should illuminate for just under 2 secs:
• PITCH STAB 1 and 2.
• ROLL STAB 1 and 2.
• YAW STAB OP and OUT.
• SPOILERS.
• HZ TAIL AUTH.
• RUDDER AUTH.
• AUTO PILOT.
• MACH TRIM.

 

In my case, these lights do not light up. Has anyone encountered a similar situation?

 

[Dentedend10]

8 hours ago, Evg85 said:

Hi all! I am studying the F-14 module and during the start-up procedure of this aircraft, I had a question.

When performing an emergency generator test, NO GO light should illuminate for about 1 sec before GO light illuminations. But in my case nothing lights up. I waited over a minute - to no avail.

Same with VMCU verification procedure. Following disengagement of MASTER TEST -EMERG GEN the following lights should illuminate for just under 2 secs:
• PITCH STAB 1 and 2.
• ROLL STAB 1 and 2.
• YAW STAB OP and OUT.
• SPOILERS.
• HZ TAIL AUTH.
• RUDDER AUTH.
• AUTO PILOT.
• MACH TRIM.

 

In my case, these lights do not light up. Has anyone encountered a similar situation?

 

Yep some of the master tests are not fully implemented currently. Hoping to see them in the future

[Evg85]

 

Clearly, this problem is not only mine.

[speed-of-heat]

seems to be the case still?

[John C Flett]

 Still an issue.

 It's frustrating trying to learn an aircraft when bits are broken. I'm never sure if the fault is mine or the modules.

[The_Tau]

Not really broken. Its just not implemented. Which to be clear, is a shame