Create SPI from F-10 Map Marker WPT

[GatorNutz]

I am trying to use GB-6 SFWs on a site that has SAMs protecting it (the SAMs shoot down the GB-6).

I know how to use "PP1" map markers (channel 36) for the GB-6, but how can I convert a map marker (e.g., "WPT1" map marker) to a SPI for the LD-10 (in Active mode so they loft)?

I tried doing a copy/paste of DEST 36 (PP1) to 40 (SPI), but that didn't seem to work. Does it require that I use a sensor to create the SPI (e.g., A2G radar or TGP)?

Thanks in advance.

[Dr_Pavelheer]

Active LD10 should fly to current waypoint unless you have something designated with radar/targeting pod/whatever

[jubuttib]

On 6/15/2023 at 2:06 AM, GatorNutz said:

I tried doing a copy/paste of DEST 36 (PP1) to 40 (SPI), but that didn't seem to work. Does it require that I use a sensor to create the SPI (e.g., A2G radar or TGP)?

Aside from what Dr_Pavelheer already said, I think what you could do is take the DEST 01 (WPT1) co-ordinates and copy/paste them to DEST 36 (or another PP slot if you need 36), that way you get a PP with the same co-ordinates as your waypoint.

[BigBorner]

You only need to do that in case you want to attack 2 Targets with different WPT markers at the same time. (PP ripple) 

if you just want to lob something at a waypoint, put the GB6 in TOO, select the WP in the UFC, make sure you don’t have anything else „locked“and let go. 
 

As the LD-10 does not really work with PP points, this is also the way to lob it at a PP or Waypoint. Select in UFC, and pickle. 

Edited July 5, 2023 by BigBorner