Problems since last update

[skypickle]

1) no reticle on pilot sight when using mistral. And even though I have a target in front of me, I never get a lock tone

2)excursion of the controls seems limited. see the attached pic. When trimmed for level flight, I have the cyclic pushed all the way forward and to the left yet the control diamond on the graph (in the upper left of the pic) shows it only halfway there. Is this intended?

[Ramsay]

58 minutes ago, skypickle said:

1) no reticle on pilot sight when using mistral. And even though I have a target in front of me, I never get a lock tone

It's a known bug - AFAIK it's already been fixed in PC's internal build and is waiting to be pushed out with ED's next patch cycle (likely sometime in July but who knows for sure).

58 minutes ago, skypickle said:

2) excursion of the controls seems limited. see the attached pic. ... Is this intended?

The cyclic has full movement in my install - so the limitation seems particular to your set up.

I suggest checking you axis settings and that Y Saturation = 100%

Note the old recommendation was to set pitch saturation between 40-60%, so if you're still using your old curves/saturations - you'll want to reset your joystick settings and fine tune from there.

Edited June 27, 2023 by Ramsay

[skypickle]

I have set saturation to 100 and no curves for both pitch and roll. My controls indicator shows the 'diamond' moving less than half way away from the center with full stick excursion.Your image does not show the controls indicator.

 

I did notice however that polychop has added 'builtin' curves. look at how much the control moves in the on screen indicator. near the zero point, moving the stick causes comparatively little motion. as you move away from the zero point the the indicators move more for the same amount of additional stick excursion.

[skypickle]

I figured it out. Unchecking a special option (module individual force feedback toggle) restored full excursion of the indicator. The chopper is also easier to control now. What is this option supposed to do? Even unchecked, my force feedback stick still provides force feedback

 

[MAXsenna]

I figured it out. Unchecking a special option (module individual force feedback toggle) restored full excursion of the indicator. The chopper is also easier to control now. What is this option supposed to do? Even unchecked, my force feedback stick still provides force feedback
 

I asked the exact same question in another thread.
My wild guess is that you can turn off FFB for the Gazelle, even if you have it enabled in the core settings.
I assume this option will be removed once the FFB has been fixed.

Cheers!

Sent from my MAR-LX1A using Tapatalk