Jump to content

Can you create mark points from just coords?


Recommended Posts

Posted

Say if a buddy sees a target and reads you the LAT/LONG over the radio? I know that you can create markpoints as an overfly point (current position), and through the t-pod, but cant' seem to be able to edit markpoint coordinates, or create a new one from coords.

Cheers for any help!

Posted
50 minutes ago, Inf said:

Say if a buddy sees a target and reads you the LAT/LONG over the radio? I know that you can create markpoints as an overfly point (current position), and through the t-pod, but cant' seem to be able to edit markpoint coordinates, or create a new one from coords.

Cheers for any help!

I'm pretty sure you can't edit markpoint coordinates, because that's one of the reasons to make one--when you make a markpoint, you can get the coordinates of that point on the gorund.

If you already have the coordinates, you'd just take an existing sequence point (or create a new one) instead, and then you can just edit its coordinates.

  • Like 1
  • Thanks 1
Posted
3 hours ago, Inf said:

Say if a buddy sees a target and reads you the LAT/LONG over the radio? I know that you can create markpoints as an overfly point (current position), and through the t-pod, but cant' seem to be able to edit markpoint coordinates, or create a new one from coords.

Cheers for any help!

How do you create overfly markpoints? I don't remember reading about it in the manual, I remember only through TGP

Pentium II 233Mhz | 16MB RAM | 14.4kb Modem | 1.44MB Floppy Disk Drive | Windows 3.1 with TM Warthog & TrackIR 5

Posted (edited)
1 hour ago, eFirehawk said:

How do you create overfly markpoints? I don't remember reading about it in the manual, I remember only through TGP

  • by using the MARK button on the ufc normally
Edited by Zboboinator
  • Like 1
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...