fixed DCS conflict with UltraLeap (dll)

[CougarFFW04]

Hi DCS developpers,

Following installation of the Ultraleap drivers and software (Ultraleap_Tracking_Installer_5.12.0.exe) and the latest DCS patch, I was unable to run DCS in VR mode. I have Investigated this problem on my side and I found the problem (I think).
It sounds that there is a conflict between the Leap dll installed by DCS...

- Uninstalled Leap tracking : DCS runs fine in VR
- Installed Leap tracking : No VR again

Solution : put the LeapC.dll and UltraleapHandTracking.dll in the DCS bin and bin-mt directories.

Would be nice if you could fix it for the next patch.
May be the opportunity to improve Leap hand tracking and to investigate the "right hand vanishing" problem in DCS because evrything run fine and smooth in the Leap tracking application so no doubt this is a DCS problem.

Thanks

[BIGNEWY]

Hi CougarFFW04 

I will take a look and try to reproduce 

thank you

[BIGNEWY]

I have installed 5.13.2+2023.06.27 for ultraleap 

It only works for me if I go into the ultraleap settings and disable openXR support