Where is the Rocket Steering Cursor?

[SharpeXB]

Why am I not seeing the RSC here?

I'm trying to use T02 as the acquisition source.

Rockets are WASd

T02 shows as the ACQ

My LOS reticle is on the target.

but no RSC... 

[NeedzWD40]

"CRKT" in the HMD indicates that only the CPG has rockets WAS'd. Is this multiplayer with a player CPG? If so, they need to select rockets via the TEDAC controller to enable COOP mode. Otherwise, get George to select no weapon so you have full control over rockets.

[SharpeXB]

5 minutes ago, NeedzWD40 said:

"CRKT" in the HMD indicates that only the CPG has rockets WAS'd. Is this multiplayer with a player CPG? If so, they need to select rockets via the TEDAC controller to enable COOP mode. Otherwise, get George to select no weapon so you have full control over rockets.

This is SP. I set George to have no weapon selected. 

[NeedzWD40]

I'd try jumping into the front seat and de-WASing rockets from the front, then jump back and see if the CRKT goes away. You should be able to override this by WAS'ing yourself, but I don't know if George is having some logic bug causing it.

Just to make sure you are WAS'ing via the key bindings and not by selecting on the WPN page?

[Floyd1212]

You don't have rockets WASed.

This indicates your CPG has rockets WASed:

This also indicates you don't have rockets WASed:

When properly WASed, as shown in the snip from the manual below, notice the differences in the areas I boxed in blue above:

You must use the binds on the cyclic or HOCAS to WAS weapons, not by pressing buttons on the MPDs.

Edited September 5, 2023 by Floyd1212

[SharpeXB]

5 minutes ago, NeedzWD40 said:

I'd try jumping into the front seat and de-WASing rockets from the front, then jump back and see if the CRKT goes away. You should be able to override this by WAS'ing yourself, but I don't know if George is having some logic bug causing it.

Just to make sure you are WAS'ing via the key bindings and not by selecting on the WPN page?

I think what happened was I went into the CPG seat and selected the rockets when storing that target. Then switched back to the pilot. DCS doesn’t sync what happens there. Like I guess it should show George take over and still have the rockets selected but when I look at the George GUI it says “no weapon”

[NeedzWD40]

2 minutes ago, SharpeXB said:

I think what happened was I went into the CPG seat and selected the rockets when storing that target.

I've had that happen before, just inverse with selecting rockets from the back seat then jumping into the front. If front WAS'd via TEDAC then it'd only go into COOP mode when the pilot selects them.

[SharpeXB]

I’ll have to give this another try to see if it repeats. But shouldn’t the RSC always be visible regardless of the mode? 

[admiki]

2 hours ago, SharpeXB said:

I’ll have to give this another try to see if it repeats. But shouldn’t the RSC always be visible regardless of the mode? 

No

[SharpeXB]

On 9/4/2023 at 11:14 PM, Floyd1212 said:

You must use the binds on the cyclic or HOCAS to WAS weapons, not by pressing buttons on the MPDs.

I realize that, I must have accidentally de-WASd them somehow. Repeatedly pressing the WAS will select and deselect so I’m must have just pressed it twice. Trying this again it works as suspected.