jackd Posted September 28, 2023 Share Posted September 28, 2023 (edited) Hi, dunno where to post this. I exchanged my ole Saitek pedals for a Crosswind v3 set. Stupid question?: Is there a way to simplify tuning the new ones, or even use the old settings straight away, etc as i have many pedal profiles tuned for my Saitek set. Default for general the Croswind v2_3 driver autoloads Axis Pitch JOY_Y, Roll JOY_X, Rudder JOY_RZ ... now there's something wrong already! Edited September 28, 2023 by jackd Link to comment Share on other sites More sharing options...
Sacarino111 Posted September 28, 2023 Share Posted September 28, 2023 Hi. If I understood your explanaition correctly, the new est of pedals are recognized but have a "new" "out of the box" setup inside DCS. If that is so, you will have to redo the setup (curves, dead zone etc.). If you saved the "Saitek setup/config", you can allways "load" that setup into the new pedals. If you do not have the SAitk setup saved, you can swap pedals back to Saitek, open DCS and save the old config. Exit DCS, swap back to new ones and load then the config, but I think this is more complicated than seting them up. Saludos. Saca111 1 Link to comment Share on other sites More sharing options...
jackd Posted September 28, 2023 Author Share Posted September 28, 2023 good tip! Link to comment Share on other sites More sharing options...
Recommended Posts