Warsaw Posted October 26, 2023 Posted October 26, 2023 (edited) New to F-16. With hotstart mission I have created, the magnetic hdg tape (MHT) on the HUD is positioned at the horizon line. In Chuck's manual the MHT is shown in a lower position on the HUD. How do I move the MHT (down) to make the horizon line less cluttered when using JDAMS? Edited October 26, 2023 by Warsaw
JesseJames38 Posted October 26, 2023 Posted October 26, 2023 From what I remember, the heading tape is at the top in normal flight and when the gear is done the tape is at the bottom of the hud. I am not sure there is a switch to change the tape location. There is a hud control panel off to your right knee to change hud display/clutter settings
Solution Terzi Posted October 26, 2023 Solution Posted October 26, 2023 In NAV mode it will be at the lower portion of the HUD. But if you choose to display DED info on the HUD it will be above. Lowering landing gear will make the heading tape float above the FPM. In AG mode it should already be on upper side. [CENTER] [/CENTER]
Recommended Posts