Usagi Posted January 6, 2024 Posted January 6, 2024 Hi, If I set rotor brake to some axis of controller, the lever in cockpit seems to move as it should and when I use something to get exported (telemetry) data, I can get lever's location updates also properly. However even though lever is fully down, engine wont start. It will start only if I raise the lever again by clicking on the cockpit and then set it again to the lowest position by clicking it.
Solution Flappie Posted January 7, 2024 Solution Posted January 7, 2024 It was reported earlier. I'll bump the internal report. ---
LuseKofte Posted January 18, 2024 Posted January 18, 2024 I always move my hot as up and down before doing anything else. This way I do not have this problem. If I spawn in with hot as in rotor brake down position the rotor brake handle will be in the correct place but still be locked. If I take it up and down there are no problems
Recommended Posts