No engine idle swich

[Gunfreak]

Technically not a bug, but there is no Wishlist.

You can only bind cut off not idle. 

I can make a work around, if I use the cut off back and froth a few times with engine off, then it will also work as idle. But other modules have their own button presses for idle. and for me with Winwing super tarus, it would be great to use those built inn idle swiches.

[RustBelt]

Idle is the opposite of cutoff. Whatever you have set for cutoff, the opposite of doing that gives you Idle.

[Gunfreak]

10 minutes ago, RustBelt said:

Idle is the opposite of cutoff. Whatever you have set for cutoff, the opposite of doing that gives you Idle.

No it doesn't. If I start the aircraft with throttle off. There is no bind to get it in idle. I can start the aircraft cold and wiggle the throttle back and forth between off and idle. And then the bind will work for idle. But there is no way to start the aircraft cold with throttle in off and just move it once into idle. That's because there isn't a separate bind for idle like there is in most other DCS jets.

[RustBelt]

Oh, yea that goes back to the whole “Match HOTAS switches” or whatever setting that never works. 
 

I run a Warthog and I have to leave it out of cutoff detent when spawning in. Then click it down into Cutoff after the plane loads in because on the Warthog they’re “held” buttons in cutoff. Also prevents issues when spawning in HOT or in the air.