borja.abadc Posted May 24, 2024 Posted May 24, 2024 (edited) Hi ! Since the last DCS version (2.9.5.55300), during start up procedures and after FBW(flight by wire) tests warning lights and sounds are crazy and M2000 is not correct configurated for the take off. It seems a bug. Edited May 24, 2024 by borja.abadc
borja.abadc Posted May 27, 2024 Author Posted May 27, 2024 M2000 after DCS upgrade is a complete mess
R.MES Posted May 27, 2024 Posted May 27, 2024 (edited) Hmmm ... no problem on my side during the startup procedure. FBW test is working (if you move several times the rudder and the stick). The only bug with this version (2.9.5.55300) I had noticed is the key binding of the Main Battery ON/OFF as I explained here : Edited May 28, 2024 by R.MES
borja.abadc Posted May 29, 2024 Author Posted May 29, 2024 En 27/5/2024 a las 20:57, R.MES dijo: Hmmm ... no problem on my side during the startup procedure. FBW test is working (if you move several times the rudder and the stick). The only bug with this version (2.9.5.55300) I had noticed is the key binding of the Main Battery ON/OFF as I explained here : Hi R.MES, Thanks for your answer but I have been flying the m2000 for many years and before FBW I always move the stick and rudder controls. I have seen in the the forum bugs section that the module has lots of bugs and many people are complaining about it. Do you sure that you have the DCS updated?
R.MES Posted May 30, 2024 Posted May 30, 2024 On 5/29/2024 at 9:31 AM, borja.abadc said: Do you sure that you have the DCS updated? Absolutely sure as I mentionned in my other post. And I confirm I have no pb during the start up procedure, no crazy lights or sounds, ... But I have no doubt there are several bugs (as in each new DCS version unfortunatly) ... like the one I have reported myself.
Recommended Posts