HP G2 lens flickering at meny/in game

[Skanky]

Hello. 

I have suddenly got flickers in my VR headsett in game after vers 2.9

Any suggestions of what i can do/troubleshoot? 

Mucho thanx

 

AMD RX 6900 XT

AMD Ryzen 7 5800X 8-Core Processor 3.80 GHz

ROG Strix X570-F Gaming

G.Skill Trident Z RGB DDR4-3600 64GB RAM

 

Edited July 4, 2024 by Skanky

[BIGNEWY]

Hi,

Check your cable, I have had it happen also, had to replace one cable, but make sure it is seated correctly and not twisted 

 

[Skanky]

I have tried a new cabel, but didnt help. 

[BIGNEWY]

try different ports on the GPU or pc if possible, otherwise I would go with a reinstall of windows mixed reality just to rule out anything strange 

[Nedum]

10 minutes ago, Skanky said:

Hello. 

I have suddenly got flickers in my VR headsett in game after vers 2.9

Any suggestions of what i can do/troubleshoot? 

Mucho thanx

 

AMD RX 6900 XT

ROG Strix X570-F Gaming

G.Skill Trident Z RGB DDR4-3600 64GB RAM

 

 

Plz check your refresh rate settings. Sounds like your Headset was set to 60 Hz

[Skanky]

Where do i check that? OpenXR or WMR? 

[Nedum]

WMR

You should find it within the Settings App.

Edit: And that what @BIGNEWY said: check this too, if my suggestion was wrong (change the USB-Ports too).

If all went wrong, disconnect your G2 completely from the PC, restart, deinstall all WMR Software, restart the PC, connect your G2 and install all the WMR software again.

Edited July 4, 2024 by Nedum

[Skanky]

90Hz

[Skanky]

null

null

[Nedum]

11 minutes ago, Skanky said:

90Hz

Disconnect your G2 completely from your PC, restart. Connect the G2 again, but use different Ports.

You are using the dcs.exe in the bin-mt folder?

Do you use any kind of tool that could limit the refresh rate (amd panel)?

Try to do a fresh installation of your gpu driver or reset the settings to standard.

Edit: Ok, try to disable Dirt and Flare and set it to none. Within the VR-Settings, disable Bloom.

 

Edited July 4, 2024 by Nedum

[Skanky]

Done, but no change. 

Yes to MT. 

No tools used.

 Ok, try to disable Dirt and Flare and set it to none. Within the VR-Settings, disable Bloom.

Didnt do anything. 

null

[firefox121]

It also happens to my Reverb G2, only a few second before take off in some demanding scenarios or missions (marianas and helis with trees and shadows), eventually stops after a few seconds, think is a power issue due to the heavy stress on my rtx 3080ti.

It stops after 10 seconds and all goes well. Try to settle down some graphic prefs and see