Joe1978 Posted July 12, 2024 Posted July 12, 2024 Hi Please, in case someone can help me: Since this last update, DCS performance has dropped by more than half. Until now I could maintain a good frame rate close to 80/90 fps. Since this last update I barely reach 45 fps (on land it is unbearableand, arround 20fps). At the same time, and I get freezes, stutters, and the ghosting in the cockpit quite pronounced. I have to activate the turbo mode in OpenXR tools to get closer to 60 fp but I still have all mentioned artifacts. In this point. flying in VR is impossible for me. Despite having bought Afghanistan, I am seriously considering going back to the previous version. My sistem HP2, 3080, 64 G ram. .
speed-of-heat Posted July 12, 2024 Posted July 12, 2024 have you by any chance been using quadviews as well ? SYSTEM SPECS: Hardware AMD 9800X3D, 64Gb RAM, 4090 FE, Virpil T50CM3 Throttle, WinWIng Orion 2 & F-16EX + MFG Crosswinds V2, Varjo Aero SOFTWARE: Microsoft Windows 11, VoiceAttack & VAICOM PRO YOUTUBE CHANNEL: @speed-of-heat
A.F. Posted July 12, 2024 Posted July 12, 2024 I have to deactivate the toolkits for my HP G2 to work at all. Have you deactivated the toolkits
Glide Posted July 12, 2024 Posted July 12, 2024 (edited) I'm guessing you have the G2 Omnicept with eye tracking. Were you using quadviews? You should be uninstalling OpenXR Toolkit now, it is not compatible with new games. Without the boost from quadviews, you will need to lower your resolution a bit, everything else being equal. Edited July 12, 2024 by Glide
Joe1978 Posted July 12, 2024 Author Posted July 12, 2024 Thanks for your answers. I deactivated the toolkits and some artifacts have disappeared/mitigated but my frame rate drops to 45 max and I still have some ghosting. What settings are you using for OpenXR? null 1 .
Glide Posted July 12, 2024 Posted July 12, 2024 I would turn off "Prefer frame rate over latency." You can set the custom resolution to 66% and work up from there. Use TAA or MSAA x4 at first as this is the sharpest. If you feel you need to raise the resolution to say 77% or higher, then try DLSS to get you satisfactory FPS.
Joe1978 Posted July 13, 2024 Author Posted July 13, 2024 hace 21 horas, Glide dijo: I would turn off "Prefer frame rate over latency." You can set the custom resolution to 66% and work up from there. Use TAA or MSAA x4 at first as this is the sharpest. If you feel you need to raise the resolution to say 77% or higher, then try DLSS to get you satisfactory FPS. Thank you. I'm doing some test with your recommendations, finger cross. .
Joe1978 Posted July 14, 2024 Author Posted July 14, 2024 At the moment, it's the best configuration that I found but I must continue adjusting some more options null .
Recommended Posts