demolish56 Posted June 9 Posted June 9 My when I put my HUD in STBY it goes blank. is anyone else experiencing this?
Solution Yurgon Posted June 9 Solution Posted June 9 Looks like the depressible pipper is fairly high in the HUD at 0 mils depression and is not visible with the default viewpoint aka the position of your pilot's virtual head. When you bring the pipper down to around 35ish mils, you should be able to see the bottom of the pipper without changing your viewpoint, and around 60 mils it should be fully visible. 1
Mathis james Posted June 20 Posted June 20 Seen cases where a faulty ignition signal prevents HUD from recognizing when the vehicle is off. Might be worth investigating electrical connections.
Dragan Posted Saturday at 02:45 PM Posted Saturday at 02:45 PM (edited) On 6/9/2025 at 11:17 PM, Yurgon said: Looks like the depressible pipper is fairly high in the HUD at 0 mils depression and is not visible with the default viewpoint aka the position of your pilot's virtual head. When you bring the pipper down to around 35ish mils, you should be able to see the bottom of the pipper without changing your viewpoint, and around 60 mils it should be fully visible. I noticed this too, and the virtual view has changed compared to the HUD at the beginning, I lower it by +5 with 0 and also lower the seat to see half of the depressible pipper, since it was too high and you can't see it from the default view.This topic is about 2 months old but I just saw it by chance. Edited Saturday at 02:48 PM by Dragan
Recommended Posts