Migow Posted January 8, 2011 Posted January 8, 2011 (edited) hi In real life , can the abris be updated by datalink ( satellite communication )from command center? i mean update of ground unit (in real time or not)? can the pilot in flight update unit on the abris (add them change their position and sam zone threat)? the shkval has a lower a "resolution" than 1024 like 300 isn't it ? why the INU isn't fully implemented? why the fire extinguisher aren't fully implemented? why the electric isn't fully implemented (the panel to check V and A) could i have more information on electric panel ammeter voltmeter?do they check all V and A on every start up? even in flight? on pvi how work the k-1 and k-2 what the abris lack on dcs from real abris?(i see sound configuration on abris mean there is sound on the real one? is precision INU alignment the most often done in real life? can we have the real ka50 start-up(documentation i mean) with all check(except iff)?how much time it take?(with inu alignment) how much times it take to ream a ka 50 completely ? how much times it take to refuel ? is it really difficult to lock target with shkval , when we set a bigger box on target and when we lock , it should resize then lock the target moving or not(if sufficient contrast) it doesn't work well in the game when target are moving ... on electric panel there is a switch "ABTБA3" what is this? how work “ВСК-СУО – ОТКЛ”? when we should have to set “ББ/ТЗ” selector. Outside temperature setting for anti-tank guided missile (ATGM) flight control system pre-launch adjustments. No function. how work “РНП” selector. Weapon control BIT mode selector. No function. “К-ЦВМ – ОТКЛ” switch. Computer BIT. No function. “АКС” button. Weapon control system BIT. No function. “Вн.К – ОТКЛ” switch. No function. “СА-ТЛФ” switch. Radio equipment data link SA-TLF switch. is it satellite radio on uhf or something for abris(gps +datalink update) ? on the shkval how work “ТР – ОТКЛ” (Tracer switch). No function.? "СФ", "К", "", "", " ", etc. color optic filters dial. This dial adjusts the Shkval optics for various weather conditions. No function. is it camera exposition ? “НПЦ” (Moving ground target mode) button. If the Shkval is tracking a moving target and you press this button prior to launching a Vikhr ATGM, the weapon control system will adjust the Vikhr launch parameters to account for a moving target and thereby increase accuracy. The targeting system will also calculate lead for gun and rockets employment. [N] it seems it doesn't work when the target move rectilinear uniform the ka50 shouldn't miss target by miscalculation “100-50” switch. This switch controls data transfer rate. when should we change it?distance bad(radio) connection? the rangefinder laser should work only at 10km why 15km in game? Edited January 8, 2011 by Fifou265 member of 06 MHR / FENNEC Mi-24P
AlphaOneSix Posted January 8, 2011 Posted January 8, 2011 hi why the fire extinguisher aren't fully implemented? how much times it take to ream a ka 50 completely ? how much times it take to refuel ? The three above are the only ones I think I can answer. Well the first one I don't have an answer for...rather, how is the fire extinguishing system not fully implemented...what is missing? Time to rearm will depend on what is being put onboard the aircraft as well as how many ground crew are involved. In my days at Apache, FARPs, the arming process usually took between 5 and 20 minutes, depending on the loadout. Time to refuel also depends, but the Ka-50's internal tanks hold just short of 1900 liters of fuel, and a typical FARP pump will put out around 150 liters per mites...so to go from empty to full would take approximately 12 minutes. Take into account that fueling and arming are NEVER done at the same time in real life, so going from nearly empty tanks and reloading a lot of ammo will probably take very close to 30 minutes.
Migow Posted January 8, 2011 Author Posted January 8, 2011 The three above are the only ones I think I can answer. Well the first one I don't have an answer for...rather, how is the fire extinguishing system not fully implemented...what is missing? Time to rearm will depend on what is being put onboard the aircraft as well as how many ground crew are involved. In my days at Apache, FARPs, the arming process usually took between 5 and 20 minutes, depending on the loadout. Time to refuel also depends, but the Ka-50's internal tanks hold just short of 1900 liters of fuel, and a typical FARP pump will put out around 150 liters per mites...so to go from empty to full would take approximately 12 minutes. Take into account that fueling and arming are NEVER done at the same time in real life, so going from nearly empty tanks and reloading a lot of ammo will probably take very close to 30 minutes. thx for answer i need it for the fire extinguisher the game lack test on sensor(there are 3 (or 2 apu)) it seems it was implemented but deleted (buggy?) member of 06 MHR / FENNEC Mi-24P
Henchman14 Posted January 8, 2011 Posted January 8, 2011 (edited) Yeah, the "automatic" extinguisher never seems to put out the fire on the engines. I think I can answer 23 from experience. If the target is moving too fast, your missile won't be able to turn that fast, and will end up flying out of the laser tunnel and lose tracking. Happens with fast moving helicopters that are moving perpendicular to you. Edited January 8, 2011 by Henchman14
Boberro Posted January 8, 2011 Posted January 8, 2011 (edited) hi the shkval has a lower a "resolution" than 1024 like 300 isn't it ? So far pictures and moves from real Shkval say it has much lower resolution than HD in BS and LO. If I remember correctly in LO1 Su-25T Shkval was much worse in picture quality. Don't know why it so good now - maybe Kamov had upgraded Shkval sensor before... but it is highly unlikely IMHO. is it really difficult to lock target with shkval , when we set a bigger box on target and when we lock , it should resize then lock the target moving or not(if sufficient contrast) it doesn't work well in the game when target are moving ... when we should have to set “ББ/ТЗ” selector. Outside temperature setting for anti-tank guided missile (ATGM) flight control system pre-launch adjustments. No function. Frankly I'd like what the hell is that too... "СФ", "К", "", "", " ", etc. color optic filters dial. This dial adjusts the Shkval optics for various weather conditions. No function. is it camera exposition ? Yes, Shkval picture can be more yellowish, grayish ect as far I noticed looking on real Shkval movies. By that you can better recognize targets I believe. “НПЦ” (Moving ground target mode) button. If the Shkval is tracking a moving target and you press this button prior to launching a Vikhr ATGM, the weapon control system will adjust the Vikhr launch parameters to account for a moving target and thereby increase accuracy. The targeting system will also calculate lead for gun and rockets employment. [N] it seems it doesn't work when the target move rectilinear uniform the ka50 shouldn't miss target by miscalculation Sometimes when target is moving right\left,up\down missile will not hit target - it will hit but ground. Don't know it is as should be or not. So far I know not all systems were made with 100% realism - due to tech limitations as example. Shkval can't lock dead targets, ect. - but in RL it should lock everything what does have contrast, shouldn't it? Edited January 8, 2011 by Boberro Reminder: Fighter pilots make movies. Bomber pilots make... HISTORY! :D | Also to be remembered: FRENCH TANKS HAVE ONE GEAR FORWARD AND FIVE BACKWARD :D ಠ_ಠ ツ
26-J39 Posted January 8, 2011 Posted January 8, 2011 could i have more information on electric panel ammeter voltmeter?do they check all V and A on every start up? even in flight? No. :P I believe ED didn't feel they had enough data here to implement the specifics you are asking for which in turn answers #6. :) why the electric isn't fully implemented (the panel to check V and A)
amalahama Posted January 8, 2011 Posted January 8, 2011 why the INU isn't fully implemented? why the electric isn't fully implemented (the panel to check V and A) could i have more information on electric panel ammeter voltmeter?do they check all V and A on every start up? even in flight? For me, these three are really annoying. Without INU drift, it makes INS updates useless, and electric system is only a stub. But about this last point, it seems DCS:W has improved electric system - it may exists a chance to see this modified as well in DCS:BS in the next compatibility patch. Regards!
Migow Posted January 13, 2011 Author Posted January 13, 2011 i need more information ;) Wags where are you?:D plz :pilotfly: especially the abris if it could be update through datalink?:music_whistling: member of 06 MHR / FENNEC Mi-24P
Recommended Posts