Jump to content

Help Please Controls....


wallace
 Share

Recommended Posts

Hello,

 

I am sure that the resources are out there but I am getting frustrated. I have spent over 2.5hrs trying to configure my CH Pro Throttle, FighterStick and my Saitek rudder peddals. It appears as though DCS wont work with all three.

 

I have downloaded and ran the CH Control Manager. I cant add the pedals to it as they are not CH. DCS does not recognize them. It does recognize my Control Manager selected control but the throttle wont work and the stick is not working properly so at this point I havent even been able to try to fly it.

 

As a RW Civi Pilot I like my realism and my controls. The thrustmaster controls are on the way but I still want to at least give this a go.

 

Any help or suggestions... places to go read or whatever would be great.

 

Cheers

Link to comment
Share on other sites

here is my CH fighterstuck und pro trottle und pro rudder profile.

 

 

the PAC-1 on stick pinky and master mode on CH mode button.

 

As for Ap, on throttle middle button, pinky button to NWS and middle finger button (close to right) is mapped to CMS Z axis.

 

hope it helps

AWAITING ED NEW DAMAGE MODEL IMPLEMENTATION FOR WW2 BIRDS

 

Fat T is above, thin T is below. Long T is faster, Short T is slower. Open triangle is AWACS, closed triangle is your own sensors. Double dash is friendly, Single dash is enemy. Circle is friendly. Strobe is jammer. Strobe to dash is under 35 km. HDD is 7 times range key. Radar to 160 km, IRST to 10 km. Stay low, but never slow.

Link to comment
Share on other sites

Hi there,

 

Thanks for the reply. Not sure if my post was clear enough. I am happy with how to assign buttons. I have tested the calibration of the loadout in CH manager before "downloading" it. But the axis of the controls dont work correctly in game.

 

I will try it again when I get home and this time I will not use CH Manager and just load the controls in the game. Aditionally though it is curious as to how the game does not recognize my rudder pedals. My saitek pedals are connected and powered and work fine with MS X so I dont know why they are not even detected in game with DCS A10.

 

I will also check the calibration in windows to see if it all works ok there and then try to see if I can figure it out.

 

Cheers

Link to comment
Share on other sites

Have you setup and cked all your axes in game//options,controls axes then pick the one to test then go to axes tune and test them here..hope that helps :thumbup:

[sIGPIC][/sIGPIC] SMOKE'M:smoke: IF YA GOT'M!:gun_rifle:

H2o Cooler I7 9700k GA 390x MB Win 10 pro

Evga RTX 2070 8Gig DD5

32 Gig Corsair Vengence, 2T SSD.

TM.Warthog:joystick: :punk:, CV-1:matrix:,3x23" monitors, Tm MFD's, Saitek pro rudders wrapped up in 2 sheets of plywood:megalol:

Link to comment
Share on other sites

 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...