Mt5_Roie Posted April 18, 2013 Posted April 18, 2013 So I have a group of USA MLRS vehicles and they are within range of enemy units. I added the target, set the radius, hit set, and pressed start firing. But on the target info at the bottom left it says "not active" and nothing happens. If I do the same thing with a paladin, it shows the aiming time and then the firing time. Is there something I'm missing? Coder - Oculus Rift Guy - Court Jester
Evil.Bonsai Posted April 18, 2013 Posted April 18, 2013 I think for the MLRS, it might take a couple minutes before they start. It's been a while since I've looked much into it, though, so it might have changed.
gunterlund21 Posted April 18, 2013 Posted April 18, 2013 check minimum range as well. I was in Art of the Kill D#@ it!!!!
Karon Posted April 19, 2013 Posted April 19, 2013 Select the MRLS and press F7 immediately after setting a new target. You should see it moving into firing position. Just to be sure, accelerate time, wait for a couple of minutes and see if something happens. If it do not shoots then you are doing something incorrectly (verify min/max range). "Cogito, ergo RIO" Virtual Backseaters Volume I: F-14 Radar Intercept Officer - Fifth Public Draft Virtual Backseaters Volume II: F-4E Weapon Systems Officer - Scrapped Phantom Articles: Air-to-Air and APQ-120 | F-4E Must-know manoevure: SYNC-Z-TURN
Spectre_USA Posted April 25, 2013 Posted April 25, 2013 Alt+J into that sucker, and let 'er rip! Getting those rascals elevation right for the target is one of the most satisfying aspects of CA. It doesn't speed up the AI firing, but it sure is fun... :D [sIGPIC][/sIGPIC] A tale of 2 hogs
Recommended Posts