Crashdown2

Yes they do

While playing on a multiplayer server on the Syria map, frame rate drops unexpectedly. Last night I was stuck on a CPU bound thread at average fps of 22. Exited when mission was done and fired up single player mission in Syria, and MT worked as expected, producing 120 to 145 fps. As a side note, in NTTR certain areas of the airfield are CPU bound, especially the open air covers, while everything else is GPU bound. Rest of map is GPU.

Chuck's guide is currently wrong. The Hornet radar used to turn off while jamming was on, but no longer, at least in TWS. I haven't seen much degradation in missile performance with jamming on, however I'm not sure how to quantify it, or measure it in the heat of combat.

On the control page, you are no longer able to cycle through AIR, GND, and GND DLY for the GBU 38 as of last update.

I noticed that there are two trim command sets, one for the stick and one for the wheel on the left panel. I have the trim hat set on the hotas and the trim wheel is left alone on the keyboard commands, however when I used the trim hat, the wheel moves as well, even though it's not assigned to it. Is this normal? Could this be our trimming problems?

All of the answers above, snarky or otherwise are correct, however the question was more simple. It does seem strange, since there are no forward firing weapons directly behind the front gear, but you kind of have to take into account maneuvering and the possibility that a weapon could smack into the gear. I do agree that doors off gear up would not necessitate the disabling of weapons, but if the bird only knows what it's told, and what it's told is limited, it's better to be safe than sorry. I run into this problem from time to time because the buttons on the throttle I have assigned to the gear don't work all of the time, (I disabled most of the keyboard stuff due to a chat issue that caused me to screw up a bunch of other stuff once on a paired mission) so I get it. It isn't always about "flying correctly", though it's important, even in the sim, there are times when things don't go as you expect, and by the time you notice, it can be too late to correct.

Simply by flying around, and then engaging targets A/G with gun and slick bombs. Right on target. Stored heading will give you the headache of missing all the time and falling back on manual mode. I think it is the stored heading option of alignment that is bugged, not quite the INS itself. However I don't code and don't have access to it, but stands to reason that if full alignment works and stored heading doesn't....

Just got home and tested it. Doing full alignment does not show drift or INS "mismatch". Stored heading will. So if you like to go without the GPS correction, then you'll have to put in the 8min 53sec worth of waiting for alignment.

I did say rarely as well with this, but sometimes I get lucky on hot starts. Keep in mind, the long alignment worked once so far. I don't have the patience to wait that long all the time :). Anyway, I am going to try it again when I get home. Make sure it wasn't a fluke.

Oddly enough, I messed up alignment with stored heading, and waited the nearly 9 minutes for alignment, and the issue wasn't there. I've also noted that servers or missions with hot starts don't have this issue either, or rarely. Wonder if it's tied to the stored heading.

When target is designated with ATFLIR, the waypoint moves along with the ground stabilized tracking, diamond can be erratic. This is different than how it used to behave. Set waypoint, designate as target, switch to ground stabilized, pan around. Need to go back? Then check waypoint and then designate as target or go back to diamond, ATFLIR slews back to original waypoint. Now where ever you move the the ground stabilized designator, the waypoint follows, and is updated in the data page on the HSI. Track included here https://drive.google.com/file/d/1P2KM7TnJppN36sO0np3UdHgW6_K9acrV/view?usp=sharing since file is too large to upload here. F/A-18 portion is first and shows the issue.

Just tried, thanks. I must have missed that somewhere.

It's called Memory Cleaner https://www.koshyjohn.com/software/memclean/

I just realized that I had the two bombs messed up... The GBU 31 works fine the GBU 38 does not. Maybe @NineLine can change the title. I'll make a vid.