Wartski

Ok, I have installed everything properly. And I edited the BigScreen file but the display is not working correctly. Also the instruction don't tell one how to set up the sim Options resolution. But I am having problems with the display. I have two monitors 1920x1200 and 1920x1080. I installed Helios and put all the files where they belong. In the BigScreen file I changed all the 5980 values to 1920, and the Center monitor 1080 height to 1200. Now in the sim Options I selected BigScreen. BUT what resolution should I use in the sim Options? and should I select Full Screen? No matter what I do the resolution when flying is either stretched or shrunk and the displayed gauges are not showing. Any help would be appreciated! Ok I found out what my problem is ... it's the ASPECT value of 5.3333333333333 which I changed to 1.6 and all is AOK!!!

I downloaded this file 'Gadroc_A10C_-_Single_Monitor.zip'. In that file are two folders 'Gadroc' and 'Scipts'. Where do they go??

Are there any instructions on how to use this HawgTouch?

The way I had my Cougar setup when using Falcon4 was to use the Up/Center/Down function of the T7/T8 button. Up for Air-to-Air, Center for Navigation and Down for Air-to-Ground. I had 186 commands programmed. I believe Falcon4 with SP2 had 315 commands. lol Two Cougars and four hands would have been perfect. Now I need to do the same for this sim.

Maybe a different position and angle for the tracker part will help. And you have to make sure it is stable and doesn't shake. I can see all around the cockpit with no blind spots.

great place for technical help http://www.sevenforums.com/ and http://forums.guru3d.com/

Sure hope armaIII runs better than armaII

I would like to jump in but my skill level with this mod leaves a lot to be desired. lol

Thanks.

So put something in there. lol

Just downloaded this today. Installed ok and was checking the manual. My question is how do you bind/use/move a DCS gauge to a position?

It would be nice if ED built into the sim the ability to move clickable gauges, and view, to other monitors.

I don't believe you with EMC. I think you have to use http://www.ipadpit.nl/index.php/about-the-a10c-ipadpit software with an iPad.

Yes! :pilotfly:

WOOPs, Yes I did put in the resolution!!!!

Thanks for the additional info!

WOOPs, Yes I did put in the resolution!!!!

You only need EMC. It creates a file with information on how you set up the controls. Then you go into the sim and in Options choose the file name from the combobox that you had created using EMC and also in Options find the Full Screen option and unselect it. Maybe if selected it will work for you but it sure didn't for me. Note that your main monitor must be considered as upper left and your second monitor will be to the right side of the main monitor, as far as Windows is concerned. Where it physically is doesn't matter. That should do it. YES you need to put into the sim Options the new resolution!!!

This post helped me!! http://forums.eagle.ru/showthread.php?t=60815 For me I had to run the sim in Windowed mode by unselecting the Full Screen option in the sim. Only then would EMC work for me.

Thanks very much!

(Up, down, left and right) When in the sim and in the cockpit? Like a seat adjustment.

Finally figured out what my problem was ... cannot be in FullScreen ... only works (for me anyway) in Windowed mode.

Works, NOT! OK, here is the problem. EMC sees the monitors correctly ... primary and secondary. BUT the game does not have the correct position of the secondary monitor. Any ideas? Is there a file that contains the critical information on the monitors setups?

Thanks much. I will give this a shot.

EMC has no affect on my system.