Jump to content

Recommended Posts

Posted

Hey guys!

I tested the M2000C again after some time yesterday, and I noticed the test panel (left side of the cockpit) is still inoperable.

This is of course a low priority bug, I just wanted to mention it since I couldn't find a recent thread about it, and I think it was working some time ago.

Posted (edited)

On the left console you have the "Fly-By-Wire and Autopilot test panel".

 

There you have to push a button after startup to have a built-in-test happening, signaling you green if everything is ok and the FBW is not in override.

 

I think it was usable in the very first version of the M2000C and it is described in the manual. It isn't working since a few version though.

In the manual version I found on the net (I am not on my PC right now) it is referenced to on pages 14 and 44.

Edited by Aginor
Posted

Oh, of course.

I was looking up front, don't know why.

 

The FBW test is OK (actually, it's a bit too nice at the moment)

The AP test never ends (no green or red light => bug) but it doesn't let you stuck with red AP alarm anymore either, so it's better.

spacer.png

Posted

Weird. When I checked two days ago I am pretty sure I could:

- click anything, and nothing obvious happened

- click the FBW switch although the guard was closed (it poked through).

 

I will re-check, perhaps it was my fault. Is it identical in 2.0 and 1.5.4 right now? I played both and now I am not sure anymore.

Posted

Yes in my last 2.0.3 flight PA test didn't work, only FBW.

[sIGPIC][/sIGPIC]

 

Intel I7 8700K / RTX 3080 / 32Go DDR4 PC21300 G.Skill Ripjaws V / MSI Z370 Gaming Pro Carbon / Cooler Master Silent Pro Gold - 1000W / Noctua NH-D14 / Acer XB270HUDbmiprz 27" G-synch 144Hz / SSD Samsung 860EVO 250Go + 1To / Cooler Master HAF X / Warthog+VPC WarBRD / Thrustmaster TPR / Track-IR v5 + Track Clip Pro / Windows 11 64bits.

Posted

It's always had this weird thing where post-test the green light would go off if you left or right clicked the switch in the manner where it didn't move (because it was already deflected in that direction for the test). Switch doesn't budge at all but the light goes out on a click.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...