Jump to content

Recommended Posts

Posted

did a short flight with the viggen in very low visibility:

i did a lot of mistakes but got her on the ground safely

 

SFMBE



Posted

Nice flight & you''re obviously a lot more proficient with the Viggen systems than me.

 

Can you tell me what was going on when the Att and Alt hold modes were blinking alternately, don't think I've seen that before so I was intrigued as what caused it

Posted

Thanks for posting. Don't usually fly jets, but really enjoyed watching someone who knows what they're doing in one.

7800x3d, 5080, 64GB, PCIE5 SSD - Oculus Pro - Moza (AB9), Virpil (Alpha, CM3, CM1 and CM2), WW (TOP and CP), TM (MFDs, Pendular Rudder), Tek Creations (F18 panel), Total Controls (Apache MFD), Jetseat 

Posted
Thanks for posting. Don't usually fly jets, but really enjoyed watching someone who knows what they're doing in one.

 

thanks, my turn at LB1 was just 2 sec. i got confused because i wanted to demonstrate how the HUD is guiding you through the circle.

SFMBE



  • 4 weeks later...
Posted (edited)
Little bit hairy there on landing! I had a mission in Cristofer's dynamic campaign which had similar visibility, but unfortunately, I got shot down before I was able to give the landing a try.

 

I knew im coming in in a 3 ° angle offset from rwy, but that 3 seems alot more when actually in the air^^

 

i think i said it already, but TILS wasnt made for this kind of bad weather. Landing Phase 3 is always a visual landing and you should see the RWY 0.5 Miles out. buts its totally doable :)

after a few rounds i was able to make much better landings in this conditions^^

Edited by whaaw

SFMBE



  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...