Ground crew wont remove F-5E chocks in 1.5

[lasvideo]

This bug is on most recent version of 1.5. I have been troubleshooting this issue for a week. The crew will place the chocks. Then after I go thru entire start up procedure they say "unable to comply" when I request they remove wheel chocks. There are no lights on the warning panel and the canopy is down. I can see the chocks are in place and can do nothing to remove them. If I do start up without the chocks then jet starts moving after engine startup if I dont continuously hold down the footbrakes which hurts and is a PITA, HELP! :)

[cofcorpse]

Are your throttles not set to IDLE? If this is the case, ground crew won't remove chocks.

[lasvideo]

Throttles at idle. No lights on warning panel. Canopy down. Wheel brakes applied (and not applied as a test). Still they refuse to remove chocks.

[Buzzles]

Throttles at idle. No lights on warning panel. Canopy down. Wheel brakes applied (and not applied as a test). Still they refuse to remove chocks.

 

Bolded the relevant part which I think is your problem. Try it with the canopy open.

Edited June 3, 2017 by Buzzles

[lasvideo]

Nope. Doesnt work with canopy up OR down ;)

[BIGNEWY]

Hi

 

please save a short track file after you exit a mission and we will take a look at it for you

 

attach the track to a post here

 

thanks

[lasvideo]

Thanks! Here is a track of me adding chocks, doing F-5E startup sequence and asking chocks to be removed with "Unable to comply" the response of the ground crew. Requested file is attached.

Chocks.miz.trk

[BIGNEWY]

Thanks! Here is a track of me adding chocks, doing F-5E startup sequence and asking chocks to be removed with "Unable to comply" the response of the ground crew. Requested file is attached.

 

thanks, just checked, your throttles are not at idle, press Rctrl + enter to see your controls indicator. Added a screenshot from your track below

 

solution:

 

Are your throttles not set to IDLE? If this is the case, ground crew won't remove chocks.

 

maybe your throttle needs calibrating?

[lasvideo]

Since I am using CH Pro Throttle, there is no detente for idle. So I assigned a button on the grip to Left Engine Idle and another button to Right Engine Idle. When starting up engines with air I use those buttons to set engine idle. Throttle was calibrated before session .